qed: Correct HW stop flow
Management firmware is used as arbiter between different PFs
which are loading/unloading, but in order to use the synchronization
it offers the contending configurations need to be applied either
between their LOAD_REQ <-> LOAD_DONE or UNLOAD_REQ <-> UNLOAD_DONE
management firmware commands.
Existing HW stop flow utilizes 2 different functions: qed_hw_stop() and
qed_hw_reset() which don't abide this requirement; Most of the closure
is doing outside the scope of the unload request.
This patch removes qed_hw_reset() and places the relevant stop
functionality underneath the management firmware protection.
Signed-off-by: Tomer Tayar <Tomer.Tayar@cavium.com>
Signed-off-by: Yuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed.h b/drivers/net/ethernet/qlogic/qed/qed.h
index ca30a27..90a1988 100644
--- a/drivers/net/ethernet/qlogic/qed/qed.h
+++ b/drivers/net/ethernet/qlogic/qed/qed.h
@@ -732,5 +732,6 @@ void qed_get_protocol_stats(struct qed_dev *cdev,
enum qed_mcp_protocol_type type,
union qed_mcp_protocol_stats *stats);
int qed_slowpath_irq_req(struct qed_hwfn *hwfn);
+void qed_slowpath_irq_sync(struct qed_hwfn *p_hwfn);
#endif /* _QED_H */