arch/tile: don't set the homecache of a PTE unless appropriate
We make sure not to try to set the home for an MMIO PTE (on tilegx)
or a PTE that isn't referencing memory managed by Linux.
Signed-off-by: Chris Metcalf <cmetcalf@tilera.com>
diff --git a/arch/tile/mm/pgtable.c b/arch/tile/mm/pgtable.c
index 8730369..6b9a109 100644
--- a/arch/tile/mm/pgtable.c
+++ b/arch/tile/mm/pgtable.c
@@ -469,10 +469,18 @@
void set_pte(pte_t *ptep, pte_t pte)
{
- struct page *page = pfn_to_page(pte_pfn(pte));
-
- /* Update the home of a PTE if necessary */
- pte = pte_set_home(pte, page_home(page));
+ if (pte_present(pte) &&
+ (!CHIP_HAS_MMIO() || hv_pte_get_mode(pte) != HV_PTE_MODE_MMIO)) {
+ /* The PTE actually references physical memory. */
+ unsigned long pfn = pte_pfn(pte);
+ if (pfn_valid(pfn)) {
+ /* Update the home of the PTE from the struct page. */
+ pte = pte_set_home(pte, page_home(pfn_to_page(pfn)));
+ } else if (hv_pte_get_mode(pte) == 0) {
+ /* remap_pfn_range(), etc, must supply PTE mode. */
+ panic("set_pte(): out-of-range PFN and mode 0\n");
+ }
+ }
__set_pte(ptep, pte);
}