extcon: usb-gpio: switch to use pm wakeirq apis
Switch to use PM wakeirq APIs which automates wakeup IRQs
enabling/disabling and so allows to make code simpler.
Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Acked-by: Tony Lindgren <tony@atomide.com>
Acked-by: Roger Quadros <rogerq@ti.com>
Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com>
diff --git a/drivers/extcon/extcon-usb-gpio.c b/drivers/extcon/extcon-usb-gpio.c
index 2b2fecf..bc61d11 100644
--- a/drivers/extcon/extcon-usb-gpio.c
+++ b/drivers/extcon/extcon-usb-gpio.c
@@ -24,6 +24,7 @@
#include <linux/module.h>
#include <linux/of_gpio.h>
#include <linux/platform_device.h>
+#include <linux/pm_wakeirq.h>
#include <linux/slab.h>
#include <linux/workqueue.h>
@@ -141,7 +142,8 @@
}
platform_set_drvdata(pdev, info);
- device_init_wakeup(dev, 1);
+ device_init_wakeup(dev, true);
+ dev_pm_set_wake_irq(dev, info->id_irq);
/* Perform initial detection */
usb_extcon_detect_cable(&info->wq_detcable.work);
@@ -155,6 +157,9 @@
cancel_delayed_work_sync(&info->wq_detcable);
+ dev_pm_clear_wake_irq(&pdev->dev);
+ device_init_wakeup(&pdev->dev, false);
+
return 0;
}
@@ -164,12 +169,6 @@
struct usb_extcon_info *info = dev_get_drvdata(dev);
int ret = 0;
- if (device_may_wakeup(dev)) {
- ret = enable_irq_wake(info->id_irq);
- if (ret)
- return ret;
- }
-
/*
* We don't want to process any IRQs after this point
* as GPIOs used behind I2C subsystem might not be
@@ -185,12 +184,6 @@
struct usb_extcon_info *info = dev_get_drvdata(dev);
int ret = 0;
- if (device_may_wakeup(dev)) {
- ret = disable_irq_wake(info->id_irq);
- if (ret)
- return ret;
- }
-
enable_irq(info->id_irq);
return ret;