usb: dwc3: fix the glue drivers using the nop phy
The reset_gpio member of the usb_phy_gen_xceiv_platform_data
structure needs the have negative value or phy-generic's
probe will fail unless DT is used. 0 is a valid gpio number.
This fixes an issue where phy-generic fails to probe with
message: "usb_phy_gen_xceiv.0: Error requesting RESET GPIO 0".
Cc: <stable@vger.kernel.org>
Signed-off-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Felipe Balbi <balbi@ti.com>
diff --git a/drivers/usb/dwc3/dwc3-pci.c b/drivers/usb/dwc3/dwc3-pci.c
index 665686e..f393c18 100644
--- a/drivers/usb/dwc3/dwc3-pci.c
+++ b/drivers/usb/dwc3/dwc3-pci.c
@@ -52,6 +52,7 @@
glue->usb2_phy = pdev;
pdata.type = USB_PHY_TYPE_USB2;
+ pdata.gpio_reset = -1;
ret = platform_device_add_data(glue->usb2_phy, &pdata, sizeof(pdata));
if (ret)