ehci: enable debugging code when CONFIG_DYNAMIC_DEBUG is set
The debugging code for ehci is enabled to run if the DEBUG flag is defined.
This patch enables the debugging code also when the kernel is configured
with dynamic debugging on.
Signed-off-by: Xenia Ragiadakou <burzalodowa@gmail.com>
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ehci-q.c b/drivers/usb/host/ehci-q.c
index cf9f2fb..e321804 100644
--- a/drivers/usb/host/ehci-q.c
+++ b/drivers/usb/host/ehci-q.c
@@ -168,13 +168,13 @@
* Note: this routine is never called for Isochronous transfers.
*/
if (urb->dev->tt && !usb_pipeint(urb->pipe) && !qh->clearing_tt) {
-#ifdef DEBUG
+#if defined(DEBUG) || defined(CONFIG_DYNAMIC_DEBUG)
struct usb_device *tt = urb->dev->tt->hub;
dev_dbg(&tt->dev,
"clear tt buffer port %d, a%d ep%d t%08x\n",
urb->dev->ttport, urb->dev->devnum,
usb_pipeendpoint(urb->pipe), token);
-#endif /* DEBUG */
+#endif /* DEBUG || CONFIG_DYNAMIC_DEBUG */
if (!ehci_is_TDI(ehci)
|| urb->dev->tt->hub !=
ehci_to_hcd(ehci)->self.root_hub) {