RTC: Convert rtc drivers to use the alarm_irq_enable method
Some rtc drivers use the ioctl method instead of the alarm_irq_enable
method for enabling alarm interupts. With the new virtualized RTC
rework, its important for drivers to use the alarm_irq_enable instead.
This patch converts the drivers that use the AIE ioctl method to
use the alarm_irq_enable method. Other ioctl cmds are left untouched.
I have not been able to test or even compile most of these drivers.
Any help to make sure this change is correct would be appreciated!
CC: Alessandro Zummo <a.zummo@towertech.it>
CC: Thomas Gleixner <tglx@linutronix.de>
CC: Marcelo Roberto Jimenez <mroberto@cpti.cetuc.puc-rio.br>
Reported-by: Marcelo Roberto Jimenez <mroberto@cpti.cetuc.puc-rio.br>
Tested-by: Marcelo Roberto Jimenez <mroberto@cpti.cetuc.puc-rio.br>
Signed-off-by: John Stultz <john.stultz@linaro.org>
diff --git a/drivers/rtc/rtc-bfin.c b/drivers/rtc/rtc-bfin.c
index b4b6087..17971d9 100644
--- a/drivers/rtc/rtc-bfin.c
+++ b/drivers/rtc/rtc-bfin.c
@@ -259,15 +259,6 @@
bfin_rtc_int_clear(~RTC_ISTAT_SEC);
break;
- case RTC_AIE_ON:
- dev_dbg_stamp(dev);
- bfin_rtc_int_set_alarm(rtc);
- break;
- case RTC_AIE_OFF:
- dev_dbg_stamp(dev);
- bfin_rtc_int_clear(~(RTC_ISTAT_ALARM | RTC_ISTAT_ALARM_DAY));
- break;
-
default:
dev_dbg_stamp(dev);
ret = -ENOIOCTLCMD;
@@ -276,6 +267,17 @@
return ret;
}
+static int bfin_rtc_alarm_irq_enable(struct device *dev, unsigned int enabled)
+{
+ struct bfin_rtc *rtc = dev_get_drvdata(dev);
+
+ dev_dbg_stamp(dev);
+ if (enabled)
+ bfin_rtc_int_set_alarm(rtc);
+ else
+ bfin_rtc_int_clear(~(RTC_ISTAT_ALARM | RTC_ISTAT_ALARM_DAY));
+}
+
static int bfin_rtc_read_time(struct device *dev, struct rtc_time *tm)
{
struct bfin_rtc *rtc = dev_get_drvdata(dev);
@@ -362,6 +364,7 @@
.read_alarm = bfin_rtc_read_alarm,
.set_alarm = bfin_rtc_set_alarm,
.proc = bfin_rtc_proc,
+ .alarm_irq_enable = bfin_rtc_alarm_irq_enable,
};
static int __devinit bfin_rtc_probe(struct platform_device *pdev)