qed: Send pf-flr as part of initialization
During HW initialization, driver would set various registers to their
needed values - but it assumes all registers start at their reset-value,
so there's no need to re-configure a register's default value.
This assumption might be incorrect, e.g., in case of preboot driver
running and initializing the driver prior to our driver.
To overcome this, we now ask management firmware to initiate a PF-flr
early during the initialization sequence. That would return everything
in the PF's scope back to default and prevent previous configurations
from still being applied.
Signed-off-by: Yuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_mcp.h b/drivers/net/ethernet/qlogic/qed/qed_mcp.h
index f76afec..0056cfe 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_mcp.h
+++ b/drivers/net/ethernet/qlogic/qed/qed_mcp.h
@@ -770,4 +770,14 @@ int qed_mcp_get_resc_info(struct qed_hwfn *p_hwfn,
struct qed_ptt *p_ptt,
struct resource_info *p_resc_info,
u32 *p_mcp_resp, u32 *p_mcp_param);
+
+/**
+ * @brief - Initiates PF FLR
+ *
+ * @param p_hwfn
+ * @param p_ptt
+ *
+ * @return int - 0 - operation was successful.
+ */
+int qed_mcp_initiate_pf_flr(struct qed_hwfn *p_hwfn, struct qed_ptt *p_ptt);
#endif