bnx2x: Fix port type display
Display the current media type connected to the port in ethtool.
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x/bnx2x_cmn.c b/drivers/net/bnx2x/bnx2x_cmn.c
index 2890443..9b24834 100644
--- a/drivers/net/bnx2x/bnx2x_cmn.c
+++ b/drivers/net/bnx2x/bnx2x_cmn.c
@@ -2803,6 +2803,55 @@
return bnx2x_nic_load(bp, LOAD_NORMAL);
}
+int bnx2x_get_cur_phy_idx(struct bnx2x *bp)
+{
+ u32 sel_phy_idx = 0;
+ if (bp->link_params.num_phys <= 1)
+ return INT_PHY;
+
+ if (bp->link_vars.link_up) {
+ sel_phy_idx = EXT_PHY1;
+ /* In case link is SERDES, check if the EXT_PHY2 is the one */
+ if ((bp->link_vars.link_status & LINK_STATUS_SERDES_LINK) &&
+ (bp->link_params.phy[EXT_PHY2].supported & SUPPORTED_FIBRE))
+ sel_phy_idx = EXT_PHY2;
+ } else {
+
+ switch (bnx2x_phy_selection(&bp->link_params)) {
+ case PORT_HW_CFG_PHY_SELECTION_HARDWARE_DEFAULT:
+ case PORT_HW_CFG_PHY_SELECTION_FIRST_PHY:
+ case PORT_HW_CFG_PHY_SELECTION_FIRST_PHY_PRIORITY:
+ sel_phy_idx = EXT_PHY1;
+ break;
+ case PORT_HW_CFG_PHY_SELECTION_SECOND_PHY:
+ case PORT_HW_CFG_PHY_SELECTION_SECOND_PHY_PRIORITY:
+ sel_phy_idx = EXT_PHY2;
+ break;
+ }
+ }
+
+ return sel_phy_idx;
+
+}
+int bnx2x_get_link_cfg_idx(struct bnx2x *bp)
+{
+ u32 sel_phy_idx = bnx2x_get_cur_phy_idx(bp);
+ /*
+ * The selected actived PHY is always after swapping (in case PHY
+ * swapping is enabled). So when swapping is enabled, we need to reverse
+ * the configuration
+ */
+
+ if (bp->link_params.multi_phy_config &
+ PORT_HW_CFG_PHY_SWAPPED_ENABLED) {
+ if (sel_phy_idx == EXT_PHY1)
+ sel_phy_idx = EXT_PHY2;
+ else if (sel_phy_idx == EXT_PHY2)
+ sel_phy_idx = EXT_PHY1;
+ }
+ return LINK_CONFIG_IDX(sel_phy_idx);
+}
+
/* called with rtnl_lock */
int bnx2x_change_mtu(struct net_device *dev, int new_mtu)
{