diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 9e0f95d..1905aa6 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -93,9 +93,13 @@
 	void __iomem		*hsmc_regs;
 	void __iomem		*sram_bank0;
 	dma_addr_t		sram_bank0_phys;
+	bool			use_nfc_sram;
 
 	bool			is_initialized;
 	struct completion	comp_nfc;
+
+	/* Point to the sram bank which include readed data via NFC */
+	void __iomem		*data_in_sram;
 };
 static struct atmel_nfc	nand_nfc;
 
@@ -247,21 +251,43 @@
 	return res;
 }
 
+static void memcpy32_fromio(void *trg, const void __iomem  *src, size_t size)
+{
+	int i;
+	u32 *t = trg;
+	const __iomem u32 *s = src;
+
+	for (i = 0; i < (size >> 2); i++)
+		*t++ = readl_relaxed(s++);
+}
+
 /*
  * Minimal-overhead PIO for data access.
  */
 static void atmel_read_buf8(struct mtd_info *mtd, u8 *buf, int len)
 {
 	struct nand_chip	*nand_chip = mtd->priv;
+	struct atmel_nand_host *host = nand_chip->priv;
 
-	__raw_readsb(nand_chip->IO_ADDR_R, buf, len);
+	if (host->nfc && host->nfc->use_nfc_sram && host->nfc->data_in_sram) {
+		memcpy32_fromio(buf, host->nfc->data_in_sram, len);
+		host->nfc->data_in_sram += len;
+	} else {
+		__raw_readsb(nand_chip->IO_ADDR_R, buf, len);
+	}
 }
 
 static void atmel_read_buf16(struct mtd_info *mtd, u8 *buf, int len)
 {
 	struct nand_chip	*nand_chip = mtd->priv;
+	struct atmel_nand_host *host = nand_chip->priv;
 
-	__raw_readsw(nand_chip->IO_ADDR_R, buf, len / 2);
+	if (host->nfc && host->nfc->use_nfc_sram && host->nfc->data_in_sram) {
+		memcpy32_fromio(buf, host->nfc->data_in_sram, len);
+		host->nfc->data_in_sram += len;
+	} else {
+		__raw_readsw(nand_chip->IO_ADDR_R, buf, len / 2);
+	}
 }
 
 static void atmel_write_buf8(struct mtd_info *mtd, const u8 *buf, int len)
@@ -283,6 +309,40 @@
 	complete(completion);
 }
 
+static int nfc_set_sram_bank(struct atmel_nand_host *host, unsigned int bank)
+{
+	/* NFC only has two banks. Must be 0 or 1 */
+	if (bank > 1)
+		return -EINVAL;
+
+	if (bank) {
+		/* Only for a 2k-page or lower flash, NFC can handle 2 banks */
+		if (host->mtd.writesize > 2048)
+			return -EINVAL;
+		nfc_writel(host->nfc->hsmc_regs, BANK, ATMEL_HSMC_NFC_BANK1);
+	} else {
+		nfc_writel(host->nfc->hsmc_regs, BANK, ATMEL_HSMC_NFC_BANK0);
+	}
+
+	return 0;
+}
+
+static uint nfc_get_sram_off(struct atmel_nand_host *host)
+{
+	if (nfc_readl(host->nfc->hsmc_regs, BANK) & ATMEL_HSMC_NFC_BANK1)
+		return NFC_SRAM_BANK1_OFFSET;
+	else
+		return 0;
+}
+
+static dma_addr_t nfc_sram_phys(struct atmel_nand_host *host)
+{
+	if (nfc_readl(host->nfc->hsmc_regs, BANK) & ATMEL_HSMC_NFC_BANK1)
+		return host->nfc->sram_bank0_phys + NFC_SRAM_BANK1_OFFSET;
+	else
+		return host->nfc->sram_bank0_phys;
+}
+
 static int atmel_nand_dma_op(struct mtd_info *mtd, void *buf, int len,
 			       int is_read)
 {
@@ -296,6 +356,7 @@
 	void *p = buf;
 	int err = -EIO;
 	enum dma_data_direction dir = is_read ? DMA_FROM_DEVICE : DMA_TO_DEVICE;
+	struct atmel_nfc *nfc = host->nfc;
 
 	if (buf >= high_memory)
 		goto err_buf;
@@ -312,7 +373,12 @@
 	}
 
 	if (is_read) {
-		dma_src_addr = host->io_phys;
+		if (nfc && nfc->data_in_sram)
+			dma_src_addr = nfc_sram_phys(host) + (nfc->data_in_sram
+				- (nfc->sram_bank0 + nfc_get_sram_off(host)));
+		else
+			dma_src_addr = host->io_phys;
+
 		dma_dst_addr = phys_addr;
 	} else {
 		dma_src_addr = phys_addr;
@@ -339,6 +405,10 @@
 	dma_async_issue_pending(host->dma_chan);
 	wait_for_completion(&host->comp);
 
+	if (is_read && nfc && nfc->data_in_sram)
+		/* After read data from SRAM, need to increase the position */
+		nfc->data_in_sram += len;
+
 	err = 0;
 
 err_dma:
@@ -850,7 +920,8 @@
 	unsigned long end_time;
 	int bitflips = 0;
 
-	pmecc_enable(host, NAND_ECC_READ);
+	if (!host->nfc || !host->nfc->use_nfc_sram)
+		pmecc_enable(host, NAND_ECC_READ);
 
 	chip->read_buf(mtd, buf, eccsize);
 	chip->read_buf(mtd, oob, mtd->oobsize);
@@ -1666,6 +1737,7 @@
 	unsigned int addr1234 = 0;
 	unsigned int cycle0 = 0;
 	bool do_addr = true;
+	host->nfc->data_in_sram = NULL;
 
 	dev_dbg(host->dev, "%s: cmd = 0x%02x, col = 0x%08x, page = 0x%08x\n",
 	     __func__, command, column, page_addr);
@@ -1707,6 +1779,16 @@
 			command = NAND_CMD_READ0; /* only READ0 is valid */
 			cmd1 = command << NFCADDR_CMD_CMD1_BIT_POS;
 		}
+		if (host->nfc->use_nfc_sram) {
+			/* Enable Data transfer to sram */
+			dataen = NFCADDR_CMD_DATAEN;
+
+			/* Need enable PMECC now, since NFC will transfer
+			 * data in bus after sending nfc read command.
+			 */
+			if (chip->ecc.mode == NAND_ECC_HW && host->has_pmecc)
+				pmecc_enable(host, NAND_ECC_READ);
+		}
 
 		cmd2 = NAND_CMD_READSTART << NFCADDR_CMD_CMD2_BIT_POS;
 		vcmd2 = NFCADDR_CMD_VCMD2;
@@ -1728,6 +1810,10 @@
 	nfc_addr_cmd = cmd1 | cmd2 | vcmd2 | acycle | csid | dataen | nfcwr;
 	nfc_send_command(host, nfc_addr_cmd, addr1234, cycle0);
 
+	if (dataen == NFCADDR_CMD_DATAEN)
+		if (nfc_wait_interrupt(host, NFC_SR_XFR_DONE))
+			dev_err(host->dev, "something wrong, No XFR_DONE interrupt comes.\n");
+
 	/*
 	 * Program and erase have their own busy handlers status, sequential
 	 * in, and deplete1 need no delay.
@@ -1745,12 +1831,66 @@
 		return;
 
 	case NAND_CMD_READ0:
+		if (dataen == NFCADDR_CMD_DATAEN) {
+			host->nfc->data_in_sram = host->nfc->sram_bank0 +
+				nfc_get_sram_off(host);
+			return;
+		}
 		/* fall through */
 	default:
 		nfc_wait_interrupt(host, NFC_SR_RB_EDGE);
 	}
 }
 
+static int nfc_sram_init(struct mtd_info *mtd)
+{
+	struct nand_chip *chip = mtd->priv;
+	struct atmel_nand_host *host = chip->priv;
+	int res = 0;
+
+	/* Initialize the NFC CFG register */
+	unsigned int cfg_nfc = 0;
+
+	/* set page size and oob layout */
+	switch (mtd->writesize) {
+	case 512:
+		cfg_nfc = NFC_CFG_PAGESIZE_512;
+		break;
+	case 1024:
+		cfg_nfc = NFC_CFG_PAGESIZE_1024;
+		break;
+	case 2048:
+		cfg_nfc = NFC_CFG_PAGESIZE_2048;
+		break;
+	case 4096:
+		cfg_nfc = NFC_CFG_PAGESIZE_4096;
+		break;
+	case 8192:
+		cfg_nfc = NFC_CFG_PAGESIZE_8192;
+		break;
+	default:
+		dev_err(host->dev, "Unsupported page size for NFC.\n");
+		res = -ENXIO;
+		return res;
+	}
+
+	/* oob bytes size = (NFCSPARESIZE + 1) * 4
+	 * Max support spare size is 512 bytes. */
+	cfg_nfc |= (((mtd->oobsize / 4) - 1) << NFC_CFG_NFC_SPARESIZE_BIT_POS
+		& NFC_CFG_NFC_SPARESIZE);
+	/* default set a max timeout */
+	cfg_nfc |= NFC_CFG_RSPARE |
+			NFC_CFG_NFC_DTOCYC | NFC_CFG_NFC_DTOMUL;
+
+	nfc_writel(host->nfc->hsmc_regs, CFG, cfg_nfc);
+
+	nfc_set_sram_bank(host, 0);
+
+	dev_info(host->dev, "Using NFC Sram read\n");
+
+	return 0;
+}
+
 static struct platform_driver atmel_nand_nfc_driver;
 /*
  * Probe for the NAND device.
@@ -1912,6 +2052,15 @@
 			goto err_hw_ecc;
 	}
 
+	/* initialize the nfc configuration register */
+	if (host->nfc && host->nfc->use_nfc_sram) {
+		res = nfc_sram_init(mtd);
+		if (res) {
+			host->nfc->use_nfc_sram = false;
+			dev_err(host->dev, "Disable use nfc sram for data transfer.\n");
+		}
+	}
+
 	/* second phase scan */
 	if (nand_scan_tail(mtd)) {
 		res = -ENXIO;
@@ -1992,11 +2141,13 @@
 	nfc_sram = platform_get_resource(pdev, IORESOURCE_MEM, 2);
 	if (nfc_sram) {
 		nfc->sram_bank0 = devm_ioremap_resource(&pdev->dev, nfc_sram);
-		if (IS_ERR(nfc->sram_bank0))
+		if (IS_ERR(nfc->sram_bank0)) {
 			dev_warn(&pdev->dev, "Fail to ioremap the NFC sram with error: %ld. So disable NFC sram.\n",
 					PTR_ERR(nfc->sram_bank0));
-		else
+		} else {
+			nfc->use_nfc_sram = true;
 			nfc->sram_bank0_phys = (dma_addr_t)nfc_sram->start;
+		}
 	}
 
 	nfc->is_initialized = true;