mtd: atmel_nand: add a new dt binding item for nand dma support
This patch will set the nand dma support in dts. Since we will not use
cpu_is_xxx() in nand driver. We needn't include the mach/cpu.h any more.
Signed-off-by: Josh Wu <josh.wu@atmel.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
diff --git a/drivers/mtd/nand/atmel_nand.c b/drivers/mtd/nand/atmel_nand.c
index 7bf912b..61d3869 100644
--- a/drivers/mtd/nand/atmel_nand.c
+++ b/drivers/mtd/nand/atmel_nand.c
@@ -43,8 +43,6 @@
#include <linux/platform_data/atmel.h>
#include <linux/pinctrl/consumer.h>
-#include <mach/cpu.h>
-
static int use_dma = 1;
module_param(use_dma, int, 0);
@@ -128,11 +126,6 @@
static struct nand_ecclayout atmel_pmecc_oobinfo;
-static int cpu_has_dma(void)
-{
- return cpu_is_at91sam9rl() || cpu_is_at91sam9g45();
-}
-
/*
* Enable NAND.
*/
@@ -1336,6 +1329,8 @@
board->on_flash_bbt = of_get_nand_on_flash_bbt(np);
+ board->has_dma = of_property_read_bool(np, "atmel,nand-has-dma");
+
if (of_get_nand_bus_width(np) == 16)
board->bus_width_16 = 1;
@@ -1600,7 +1595,7 @@
nand_chip->bbt_options |= NAND_BBT_USE_FLASH;
}
- if (!cpu_has_dma())
+ if (!host->board.has_dma)
use_dma = 0;
if (use_dma) {