net: sh_eth: Fix timing of RACT setting in sh_eth_rx()
This patch fixes an issue that we cannot use nfs rootfs correctly
on r8a7790 when the command below runs on a host PC.
$ sudo ping -f -l 8 $BOARD_IP_ADDR
Since the driver sets the RACT to 1 in the first while loop of
sh_eth_rx(), the controller accepts a next frame into the next RX
descriptor during the while loop. But, in the first while loop
doesn't allocate a next skb. So, this patch removes the RACT setting
in the first while loop of sh_eth_rx().
Signed-off-by: Yoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index 606dabd..7622213 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
@@ -1460,7 +1460,6 @@
ndev->stats.rx_packets++;
ndev->stats.rx_bytes += pkt_len;
}
- rxdesc->status |= cpu_to_edmac(mdp, RD_RACT);
entry = (++mdp->cur_rx) % mdp->num_rx_ring;
rxdesc = &mdp->rx_ring[entry];
}