i40e: ATR policy change to flush the table to clean stale ATR rules
Instead of disabling ATR when we get a programming error, we now
will wait it out to see if some room gets created by ATR rule deletion.
If we still have too many errors and ATR filter count did not change
much, its time to flush and replay. We no more auto-disable ATR when
we have errors in programming.
The disabling of ATR when we get programming error was buggy and
was still adding new rules and causing continuous errors. With this
policy change we flush instead when we see too many errors.
ATR is still disabled if we add a SB rule for TCP/IPv4 flow type,
more logic is added to re-enable it once all SB TCP/IPv4 rules are gone.
Change-ID: I77edcbeab9500c72a7e0bd7b5c5b113ced133a9c
Signed-off-by: Anjali Singhai Jain <anjali.singhai@intel.com>
Tested-by: Jim Young <jamesx.m.young@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/i40e/i40e.h b/drivers/net/ethernet/intel/i40e/i40e.h
index 801da39..0c6a9b9 100644
--- a/drivers/net/ethernet/intel/i40e/i40e.h
+++ b/drivers/net/ethernet/intel/i40e/i40e.h
@@ -144,6 +144,7 @@
__I40E_PTP_TX_IN_PROGRESS,
__I40E_BAD_EEPROM,
__I40E_DOWN_REQUESTED,
+ __I40E_FD_FLUSH_REQUESTED,
};
enum i40e_interrupt_policy {
@@ -250,6 +251,10 @@
u16 fdir_pf_active_filters;
u16 fd_sb_cnt_idx;
u16 fd_atr_cnt_idx;
+ unsigned long fd_flush_timestamp;
+ u32 fd_add_err;
+ u32 fd_atr_cnt;
+ u32 fd_tcp_rule;
#ifdef CONFIG_I40E_VXLAN
__be16 vxlan_ports[I40E_MAX_PF_UDP_OFFLOAD_PORTS];
@@ -608,6 +613,7 @@
void i40e_fdir_check_and_reenable(struct i40e_pf *pf);
int i40e_get_current_fd_count(struct i40e_pf *pf);
int i40e_get_cur_guaranteed_fd_count(struct i40e_pf *pf);
+int i40e_get_current_atr_cnt(struct i40e_pf *pf);
bool i40e_set_ntuple(struct i40e_pf *pf, netdev_features_t features);
void i40e_set_ethtool_ops(struct net_device *netdev);
struct i40e_mac_filter *i40e_add_filter(struct i40e_vsi *vsi,