netxen: annotate board_config and board_type
Remove huge board config structure from each instance, read
only necessary fields from flash.
Replace board_type with port_type (1G/10G), there's another
board_type field describing card type (SFP/XFP/CX4).
Signed-off-by: Dhananjay Phadke <dhananjay@netxen.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/netxen/netxen_nic_ethtool.c b/drivers/net/netxen/netxen_nic_ethtool.c
index f811880..8b4bdfd 100644
--- a/drivers/net/netxen/netxen_nic_ethtool.c
+++ b/drivers/net/netxen/netxen_nic_ethtool.c
@@ -115,10 +115,9 @@
netxen_nic_get_settings(struct net_device *dev, struct ethtool_cmd *ecmd)
{
struct netxen_adapter *adapter = netdev_priv(dev);
- struct netxen_board_info *boardinfo = &adapter->ahw.boardcfg;
/* read which mode */
- if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
+ if (adapter->ahw.port_type == NETXEN_NIC_GBE) {
ecmd->supported = (SUPPORTED_10baseT_Half |
SUPPORTED_10baseT_Full |
SUPPORTED_100baseT_Half |
@@ -137,7 +136,7 @@
ecmd->duplex = adapter->link_duplex;
ecmd->autoneg = adapter->link_autoneg;
- } else if (adapter->ahw.board_type == NETXEN_NIC_XGBE) {
+ } else if (adapter->ahw.port_type == NETXEN_NIC_XGBE) {
u32 val;
adapter->hw_read_wx(adapter, NETXEN_PORT_MODE_ADDR, &val, 4);
@@ -169,7 +168,7 @@
ecmd->phy_address = adapter->physical_port;
ecmd->transceiver = XCVR_EXTERNAL;
- switch ((netxen_brdtype_t) boardinfo->board_type) {
+ switch ((netxen_brdtype_t)adapter->ahw.board_type) {
case NETXEN_BRDTYPE_P2_SB35_4G:
case NETXEN_BRDTYPE_P2_SB31_2G:
case NETXEN_BRDTYPE_P3_REF_QG:
@@ -185,7 +184,7 @@
ecmd->supported |= SUPPORTED_TP;
ecmd->advertising |= ADVERTISED_TP;
ecmd->port = PORT_TP;
- ecmd->autoneg = (boardinfo->board_type ==
+ ecmd->autoneg = (adapter->ahw.board_type ==
NETXEN_BRDTYPE_P2_SB31_10G_CX4) ?
(AUTONEG_DISABLE) : (adapter->link_autoneg);
break;
@@ -212,7 +211,7 @@
ecmd->autoneg = AUTONEG_DISABLE;
break;
case NETXEN_BRDTYPE_P3_10G_TP:
- if (adapter->ahw.board_type == NETXEN_NIC_XGBE) {
+ if (adapter->ahw.port_type == NETXEN_NIC_XGBE) {
ecmd->autoneg = AUTONEG_DISABLE;
ecmd->supported |= (SUPPORTED_FIBRE | SUPPORTED_TP);
ecmd->advertising |=
@@ -228,7 +227,7 @@
break;
default:
printk(KERN_ERR "netxen-nic: Unsupported board model %d\n",
- (netxen_brdtype_t) boardinfo->board_type);
+ (netxen_brdtype_t)adapter->ahw.board_type);
return -EIO;
}
@@ -242,7 +241,7 @@
__u32 status;
/* read which mode */
- if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
+ if (adapter->ahw.port_type == NETXEN_NIC_GBE) {
/* autonegotiation */
if (adapter->phy_write
&& adapter->phy_write(adapter,
@@ -430,7 +429,7 @@
int val;
/* read which mode */
- if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
+ if (adapter->ahw.port_type == NETXEN_NIC_GBE) {
if (adapter->phy_read
&& adapter->phy_read(adapter,
NETXEN_NIU_GB_MII_MGMT_ADDR_PHY_STATUS,
@@ -440,7 +439,7 @@
val = netxen_get_phy_link(status);
return !val;
}
- } else if (adapter->ahw.board_type == NETXEN_NIC_XGBE) {
+ } else if (adapter->ahw.port_type == NETXEN_NIC_XGBE) {
val = adapter->pci_read_normalize(adapter, CRB_XG_STATE);
return (val == XG_LINK_UP) ? 0 : 1;
}
@@ -483,7 +482,7 @@
rds_rings[RCV_DESC_JUMBO_CTXID].max_rx_desc_count;
ring->tx_pending = adapter->max_tx_desc_count;
- if (adapter->ahw.board_type == NETXEN_NIC_GBE)
+ if (adapter->ahw.port_type == NETXEN_NIC_GBE)
ring->rx_max_pending = MAX_RCV_DESCRIPTORS_1G;
else
ring->rx_max_pending = MAX_RCV_DESCRIPTORS_10G;
@@ -501,7 +500,7 @@
__u32 val;
int port = adapter->physical_port;
- if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
+ if (adapter->ahw.port_type == NETXEN_NIC_GBE) {
if ((port < 0) || (port > NETXEN_NIU_MAX_GBE_PORTS))
return;
/* get flow control settings */
@@ -524,7 +523,7 @@
pause->tx_pause = !(netxen_gb_get_gb3_mask(val));
break;
}
- } else if (adapter->ahw.board_type == NETXEN_NIC_XGBE) {
+ } else if (adapter->ahw.port_type == NETXEN_NIC_XGBE) {
if ((port < 0) || (port > NETXEN_NIU_MAX_XG_PORTS))
return;
pause->rx_pause = 1;
@@ -535,7 +534,7 @@
pause->tx_pause = !(netxen_xg_get_xg1_mask(val));
} else {
printk(KERN_ERR"%s: Unknown board type: %x\n",
- netxen_nic_driver_name, adapter->ahw.board_type);
+ netxen_nic_driver_name, adapter->ahw.port_type);
}
}
@@ -547,7 +546,7 @@
__u32 val;
int port = adapter->physical_port;
/* read mode */
- if (adapter->ahw.board_type == NETXEN_NIC_GBE) {
+ if (adapter->ahw.port_type == NETXEN_NIC_GBE) {
if ((port < 0) || (port > NETXEN_NIU_MAX_GBE_PORTS))
return -EIO;
/* set flow control */
@@ -591,7 +590,7 @@
break;
}
netxen_nic_write_w0(adapter, NETXEN_NIU_GB_PAUSE_CTL, val);
- } else if (adapter->ahw.board_type == NETXEN_NIC_XGBE) {
+ } else if (adapter->ahw.port_type == NETXEN_NIC_XGBE) {
if ((port < 0) || (port > NETXEN_NIU_MAX_XG_PORTS))
return -EIO;
netxen_nic_read_w0(adapter, NETXEN_NIU_XG_PAUSE_CTL, &val);
@@ -610,7 +609,7 @@
} else {
printk(KERN_ERR "%s: Unknown board type: %x\n",
netxen_nic_driver_name,
- adapter->ahw.board_type);
+ adapter->ahw.port_type);
}
return 0;
}