The ixp2000 driver for the enp2611 was developed on a board with
three gigabit ports, but some enp2611 models only have two ports
(and only one onboard PM3386.) The current driver assumes there
are always three ports and so it doesn't work on the two-port
version of the board at all.
This patch adds a bit of logic to the enp2611 driver to limit the
number of ports to 2 if the second PM3386 isn't detected.
Signed-off-by: Lennert Buytenhek <buytenh@wantstofly.org>
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
diff --git a/drivers/net/ixp2000/enp2611.c b/drivers/net/ixp2000/enp2611.c
index 6f7dce8..b67f586 100644
--- a/drivers/net/ixp2000/enp2611.c
+++ b/drivers/net/ixp2000/enp2611.c
@@ -149,6 +149,8 @@
int status;
dev = nds[i];
+ if (dev == NULL)
+ continue;
status = pm3386_is_link_up(i);
if (status && !netif_carrier_ok(dev)) {
@@ -191,6 +193,7 @@
static int __init enp2611_init_module(void)
{
+ int ports;
int i;
if (!machine_is_enp2611())
@@ -199,7 +202,8 @@
caleb_reset();
pm3386_reset();
- for (i = 0; i < 3; i++) {
+ ports = pm3386_port_count();
+ for (i = 0; i < ports; i++) {
nds[i] = ixpdev_alloc(i, sizeof(struct enp2611_ixpdev_priv));
if (nds[i] == NULL) {
while (--i >= 0)
@@ -215,9 +219,10 @@
ixp2400_msf_init(&enp2611_msf_parameters);
- if (ixpdev_init(3, nds, enp2611_set_port_admin_status)) {
- for (i = 0; i < 3; i++)
- free_netdev(nds[i]);
+ if (ixpdev_init(ports, nds, enp2611_set_port_admin_status)) {
+ for (i = 0; i < ports; i++)
+ if (nds[i])
+ free_netdev(nds[i]);
return -EINVAL;
}