[SCSI] aacraid: add support for handling ATA pass-through commands.
There are two conditions for ATA pass thru command that falls into
'SRB_STATUS_ERROR' condition.
1. When the "CC" bit is set by the host in ATA pass-through CDB
- Even for the successful completion, SCSI target shall generate
check condition.
- Driver returns a result code of SAM_STAT_CHECK_CONDITION, with a
driver byte of DID_OK to the mid layer.
Below is the snippet of existing code which fills a result code
of SAM_STAT_CHECK_CONDITION:
***********************************
if (le32_to_cpu(srbreply->scsi_status) == SAM_STAT_CHECK_CONDITION) {
int len;
scsicmd->result |= SAM_STAT_CHECK_CONDITION;
..........
************************************
2. When the "CC" bit is reset by the host and if SCSI target generates
a check condition when an error occurs.
- Driver returns a result code of SAM_STAT_CHECK_CONDITION, with a
driver byte of DID_ERROR to the mid layer.
Signed-off-by: Mahesh Rajashekhara <aacraid@adaptec.com>
Signed-off-by: James Bottomley <James.Bottomley@suse.de>
diff --git a/drivers/scsi/aacraid/aachba.c b/drivers/scsi/aacraid/aachba.c
index 24b1ba0..fdc7d99 100644
--- a/drivers/scsi/aacraid/aachba.c
+++ b/drivers/scsi/aacraid/aachba.c
@@ -2693,8 +2693,22 @@
scsicmd->cmnd[0],
le32_to_cpu(srbreply->scsi_status));
#endif
- scsicmd->result = DID_ERROR << 16 | COMMAND_COMPLETE << 8;
- break;
+ if ((scsicmd->cmnd[0] == ATA_12)
+ || (scsicmd->cmnd[0] == ATA_16)) {
+ if (scsicmd->cmnd[2] & (0x01 << 5)) {
+ scsicmd->result = DID_OK << 16
+ | COMMAND_COMPLETE << 8;
+ break;
+ } else {
+ scsicmd->result = DID_ERROR << 16
+ | COMMAND_COMPLETE << 8;
+ break;
+ }
+ } else {
+ scsicmd->result = DID_ERROR << 16
+ | COMMAND_COMPLETE << 8;
+ break;
+ }
}
if (le32_to_cpu(srbreply->scsi_status) == SAM_STAT_CHECK_CONDITION) {
int len;