of: Transactional DT support.
Introducing DT transactional support.
A DT transaction is a method which allows one to apply changes
in the live tree, in such a way that either the full set of changes
take effect, or the state of the tree can be rolled-back to the
state it was before it was attempted. An applied transaction
can be rolled-back at any time.
Documentation is in
Documentation/devicetree/changesets.txt
Signed-off-by: Pantelis Antoniou <pantelis.antoniou@konsulko.com>
[glikely: Removed device notifiers and reworked to be more consistent]
Signed-off-by: Grant Likely <grant.likely@linaro.org>
diff --git a/Documentation/devicetree/changesets.txt b/Documentation/devicetree/changesets.txt
new file mode 100644
index 0000000..935ba5a
--- /dev/null
+++ b/Documentation/devicetree/changesets.txt
@@ -0,0 +1,40 @@
+A DT changeset is a method which allows one to apply changes
+in the live tree in such a way that either the full set of changes
+will be applied, or none of them will be. If an error occurs partway
+through applying the changeset, then the tree will be rolled back to the
+previous state. A changeset can also be removed after it has been
+applied.
+
+When a changeset is applied, all of the changes get applied to the tree
+at once before emitting OF_RECONFIG notifiers. This is so that the
+receiver sees a complete and consistent state of the tree when it
+receives the notifier.
+
+The sequence of a changeset is as follows.
+
+1. of_changeset_init() - initializes a changeset
+
+2. A number of DT tree change calls, of_changeset_attach_node(),
+of_changeset_detach_node(), of_changeset_add_property(),
+of_changeset_remove_property, of_changeset_update_property() to prepare
+a set of changes. No changes to the active tree are made at this point.
+All the change operations are recorded in the of_changeset 'entries'
+list.
+
+3. mutex_lock(of_mutex) - starts a changeset; The global of_mutex
+ensures there can only be one editor at a time.
+
+4. of_changeset_apply() - Apply the changes to the tree. Either the
+entire changeset will get applied, or if there is an error the tree will
+be restored to the previous state
+
+5. mutex_unlock(of_mutex) - All operations complete, release the mutex
+
+If a successfully applied changeset needs to be removed, it can be done
+with the following sequence.
+
+1. mutex_lock(of_mutex)
+
+2. of_changeset_revert()
+
+3. mutex_unlock(of_mutex)