| // SPDX-License-Identifier: GPL-2.0+ |
| /* |
| * Watchdog driver for the SA11x0/PXA2xx |
| * |
| * (c) Copyright 2000 Oleg Drokin <green@crimea.edu> |
| * Based on SoftDog driver by Alan Cox <alan@lxorguk.ukuu.org.uk> |
| * |
| * Neither Oleg Drokin nor iXcelerator.com admit liability nor provide |
| * warranty for any of this software. This material is provided |
| * "AS-IS" and at no charge. |
| * |
| * (c) Copyright 2000 Oleg Drokin <green@crimea.edu> |
| * |
| * 27/11/2000 Initial release |
| */ |
| |
| #define pr_fmt(fmt) KBUILD_MODNAME ": " fmt |
| |
| #include <linux/module.h> |
| #include <linux/moduleparam.h> |
| #include <linux/clk.h> |
| #include <linux/types.h> |
| #include <linux/kernel.h> |
| #include <linux/fs.h> |
| #include <linux/miscdevice.h> |
| #include <linux/watchdog.h> |
| #include <linux/init.h> |
| #include <linux/io.h> |
| #include <linux/bitops.h> |
| #include <linux/uaccess.h> |
| #include <linux/timex.h> |
| |
| #ifdef CONFIG_ARCH_PXA |
| #include <mach/regs-ost.h> |
| #endif |
| |
| #include <mach/reset.h> |
| #include <mach/hardware.h> |
| |
| static unsigned long oscr_freq; |
| static unsigned long sa1100wdt_users; |
| static unsigned int pre_margin; |
| static int boot_status; |
| |
| /* |
| * Allow only one person to hold it open |
| */ |
| static int sa1100dog_open(struct inode *inode, struct file *file) |
| { |
| if (test_and_set_bit(1, &sa1100wdt_users)) |
| return -EBUSY; |
| |
| /* Activate SA1100 Watchdog timer */ |
| writel_relaxed(readl_relaxed(OSCR) + pre_margin, OSMR3); |
| writel_relaxed(OSSR_M3, OSSR); |
| writel_relaxed(OWER_WME, OWER); |
| writel_relaxed(readl_relaxed(OIER) | OIER_E3, OIER); |
| return stream_open(inode, file); |
| } |
| |
| /* |
| * The watchdog cannot be disabled. |
| * |
| * Previous comments suggested that turning off the interrupt by |
| * clearing OIER[E3] would prevent the watchdog timing out but this |
| * does not appear to be true (at least on the PXA255). |
| */ |
| static int sa1100dog_release(struct inode *inode, struct file *file) |
| { |
| pr_crit("Device closed - timer will not stop\n"); |
| clear_bit(1, &sa1100wdt_users); |
| return 0; |
| } |
| |
| static ssize_t sa1100dog_write(struct file *file, const char __user *data, |
| size_t len, loff_t *ppos) |
| { |
| if (len) |
| /* Refresh OSMR3 timer. */ |
| writel_relaxed(readl_relaxed(OSCR) + pre_margin, OSMR3); |
| return len; |
| } |
| |
| static const struct watchdog_info ident = { |
| .options = WDIOF_CARDRESET | WDIOF_SETTIMEOUT |
| | WDIOF_KEEPALIVEPING, |
| .identity = "SA1100/PXA255 Watchdog", |
| .firmware_version = 1, |
| }; |
| |
| static long sa1100dog_ioctl(struct file *file, unsigned int cmd, |
| unsigned long arg) |
| { |
| int ret = -ENOTTY; |
| int time; |
| void __user *argp = (void __user *)arg; |
| int __user *p = argp; |
| |
| switch (cmd) { |
| case WDIOC_GETSUPPORT: |
| ret = copy_to_user(argp, &ident, |
| sizeof(ident)) ? -EFAULT : 0; |
| break; |
| |
| case WDIOC_GETSTATUS: |
| ret = put_user(0, p); |
| break; |
| |
| case WDIOC_GETBOOTSTATUS: |
| ret = put_user(boot_status, p); |
| break; |
| |
| case WDIOC_KEEPALIVE: |
| writel_relaxed(readl_relaxed(OSCR) + pre_margin, OSMR3); |
| ret = 0; |
| break; |
| |
| case WDIOC_SETTIMEOUT: |
| ret = get_user(time, p); |
| if (ret) |
| break; |
| |
| if (time <= 0 || (oscr_freq * (long long)time >= 0xffffffff)) { |
| ret = -EINVAL; |
| break; |
| } |
| |
| pre_margin = oscr_freq * time; |
| writel_relaxed(readl_relaxed(OSCR) + pre_margin, OSMR3); |
| /*fall through*/ |
| |
| case WDIOC_GETTIMEOUT: |
| ret = put_user(pre_margin / oscr_freq, p); |
| break; |
| } |
| return ret; |
| } |
| |
| static const struct file_operations sa1100dog_fops = { |
| .owner = THIS_MODULE, |
| .llseek = no_llseek, |
| .write = sa1100dog_write, |
| .unlocked_ioctl = sa1100dog_ioctl, |
| .open = sa1100dog_open, |
| .release = sa1100dog_release, |
| }; |
| |
| static struct miscdevice sa1100dog_miscdev = { |
| .minor = WATCHDOG_MINOR, |
| .name = "watchdog", |
| .fops = &sa1100dog_fops, |
| }; |
| |
| static int margin __initdata = 60; /* (secs) Default is 1 minute */ |
| static struct clk *clk; |
| |
| static int __init sa1100dog_init(void) |
| { |
| int ret; |
| |
| clk = clk_get(NULL, "OSTIMER0"); |
| if (IS_ERR(clk)) { |
| pr_err("SA1100/PXA2xx Watchdog Timer: clock not found: %d\n", |
| (int) PTR_ERR(clk)); |
| return PTR_ERR(clk); |
| } |
| |
| ret = clk_prepare_enable(clk); |
| if (ret) { |
| pr_err("SA1100/PXA2xx Watchdog Timer: clock failed to prepare+enable: %d\n", |
| ret); |
| goto err; |
| } |
| |
| oscr_freq = clk_get_rate(clk); |
| |
| /* |
| * Read the reset status, and save it for later. If |
| * we suspend, RCSR will be cleared, and the watchdog |
| * reset reason will be lost. |
| */ |
| boot_status = (reset_status & RESET_STATUS_WATCHDOG) ? |
| WDIOF_CARDRESET : 0; |
| pre_margin = oscr_freq * margin; |
| |
| ret = misc_register(&sa1100dog_miscdev); |
| if (ret == 0) { |
| pr_info("SA1100/PXA2xx Watchdog Timer: timer margin %d sec\n", |
| margin); |
| return 0; |
| } |
| |
| clk_disable_unprepare(clk); |
| err: |
| clk_put(clk); |
| return ret; |
| } |
| |
| static void __exit sa1100dog_exit(void) |
| { |
| misc_deregister(&sa1100dog_miscdev); |
| clk_disable_unprepare(clk); |
| clk_put(clk); |
| } |
| |
| module_init(sa1100dog_init); |
| module_exit(sa1100dog_exit); |
| |
| MODULE_AUTHOR("Oleg Drokin <green@crimea.edu>"); |
| MODULE_DESCRIPTION("SA1100/PXA2xx Watchdog"); |
| |
| module_param(margin, int, 0); |
| MODULE_PARM_DESC(margin, "Watchdog margin in seconds (default 60s)"); |
| |
| MODULE_LICENSE("GPL"); |