cxgb4: Fix FW flash logic using ethtool
Use t4_fw_upgrade instead of t4_load_fw to write firmware into FLASH, since
t4_load_fw doesn't co-ordinate with the firmware and the adapter can get hosed
enough to require a power cycle of the system.
Based on original work by Casey Leedom <leedom@chelsio.com>
Signed-off-by: Hariprasad Shenai <hariprasad@chelsio.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/chelsio/cxgb4/cxgb4_main.c b/drivers/net/ethernet/chelsio/cxgb4/cxgb4_main.c
index 5b38e95..fed8f26 100644
--- a/drivers/net/ethernet/chelsio/cxgb4/cxgb4_main.c
+++ b/drivers/net/ethernet/chelsio/cxgb4/cxgb4_main.c
@@ -2929,16 +2929,26 @@
int ret;
const struct firmware *fw;
struct adapter *adap = netdev2adap(netdev);
+ unsigned int mbox = FW_PCIE_FW_MASTER_MASK + 1;
ef->data[sizeof(ef->data) - 1] = '\0';
ret = request_firmware(&fw, ef->data, adap->pdev_dev);
if (ret < 0)
return ret;
- ret = t4_load_fw(adap, fw->data, fw->size);
+ /* If the adapter has been fully initialized then we'll go ahead and
+ * try to get the firmware's cooperation in upgrading to the new
+ * firmware image otherwise we'll try to do the entire job from the
+ * host ... and we always "force" the operation in this path.
+ */
+ if (adap->flags & FULL_INIT_DONE)
+ mbox = adap->mbox;
+
+ ret = t4_fw_upgrade(adap, mbox, fw->data, fw->size, 1);
release_firmware(fw);
if (!ret)
- dev_info(adap->pdev_dev, "loaded firmware %s\n", ef->data);
+ dev_info(adap->pdev_dev, "loaded firmware %s,"
+ " reload cxgb4 driver\n", ef->data);
return ret;
}