wl1271: fix a bunch of sparse warnings
A couple of sparse warnings in some rate settings (missing cpu_to_le32) were
fixed. Changed the conf_sg_settings struct from le to native endianess. The
values are converted to le when copying them to the acx command instead.
Reported-by: Johannes Berg <johannes@sipsolutions.net>
Signed-off-by: Luciano Coelho <luciano.coelho@nokia.com>
Reviewed-by: Juuso Oikarinen <juuso.oikarinen@nokia.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/wl12xx/wl1271_boot.c b/drivers/net/wireless/wl12xx/wl1271_boot.c
index f16d15b..7e79715 100644
--- a/drivers/net/wireless/wl12xx/wl1271_boot.c
+++ b/drivers/net/wireless/wl12xx/wl1271_boot.c
@@ -350,7 +350,7 @@
static int wl1271_boot_run_firmware(struct wl1271 *wl)
{
int loop, ret;
- u32 chip_id, interrupt;
+ u32 chip_id, intr;
wl1271_boot_set_ecpu_ctrl(wl, ECPU_CONTROL_HALT);
@@ -367,15 +367,15 @@
loop = 0;
while (loop++ < INIT_LOOP) {
udelay(INIT_LOOP_DELAY);
- interrupt = wl1271_read32(wl, ACX_REG_INTERRUPT_NO_CLEAR);
+ intr = wl1271_read32(wl, ACX_REG_INTERRUPT_NO_CLEAR);
- if (interrupt == 0xffffffff) {
+ if (intr == 0xffffffff) {
wl1271_error("error reading hardware complete "
"init indication");
return -EIO;
}
/* check that ACX_INTR_INIT_COMPLETE is enabled */
- else if (interrupt & WL1271_ACX_INTR_INIT_COMPLETE) {
+ else if (intr & WL1271_ACX_INTR_INIT_COMPLETE) {
wl1271_write32(wl, ACX_REG_INTERRUPT_ACK,
WL1271_ACX_INTR_INIT_COMPLETE);
break;