bnx2: disable toggling of rxvlan if necessary
The bnx2 driver uses .ndo_fix_features to force enable of Rx VLAN tag
stripping when the card cannot disable it. The driver should remove
NETIF_F_HW_VLAN_CTAG_RX flag from hw_features instead so it is fixed
for the ethtool.
Cc: Sony Chacko <sony.chacko@qlogic.com>
Cc: Dept-HSGLinuxNICDev@qlogic.com
Signed-off-by: Ivan Vecera <ivecera@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2.c b/drivers/net/ethernet/broadcom/bnx2.c
index 9f146b9..2b66ef3 100644
--- a/drivers/net/ethernet/broadcom/bnx2.c
+++ b/drivers/net/ethernet/broadcom/bnx2.c
@@ -7708,17 +7708,6 @@
return 0;
}
-static netdev_features_t
-bnx2_fix_features(struct net_device *dev, netdev_features_t features)
-{
- struct bnx2 *bp = netdev_priv(dev);
-
- if (!(bp->flags & BNX2_FLAG_CAN_KEEP_VLAN))
- features |= NETIF_F_HW_VLAN_CTAG_RX;
-
- return features;
-}
-
static int
bnx2_set_features(struct net_device *dev, netdev_features_t features)
{
@@ -8525,7 +8514,6 @@
.ndo_validate_addr = eth_validate_addr,
.ndo_set_mac_address = bnx2_change_mac_addr,
.ndo_change_mtu = bnx2_change_mtu,
- .ndo_fix_features = bnx2_fix_features,
.ndo_set_features = bnx2_set_features,
.ndo_tx_timeout = bnx2_tx_timeout,
#ifdef CONFIG_NET_POLL_CONTROLLER
@@ -8576,6 +8564,9 @@
dev->features |= dev->hw_features;
dev->priv_flags |= IFF_UNICAST_FLT;
+ if (!(bp->flags & BNX2_FLAG_CAN_KEEP_VLAN))
+ dev->hw_features &= ~NETIF_F_HW_VLAN_CTAG_RX;
+
if ((rc = register_netdev(dev))) {
dev_err(&pdev->dev, "Cannot register net device\n");
goto error;