ath6kl: support TX error rate notification
The ath6kl firmware can monitor a connection and report when a certain
TX failure threshold is crossed. Support this configuration and event
reporting on compatible firmwares.
Signed-off-by: Thomas Pedersen <c_tpeder@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath6kl/cfg80211.c b/drivers/net/wireless/ath/ath6kl/cfg80211.c
index a624a0c..0194617 100644
--- a/drivers/net/wireless/ath/ath6kl/cfg80211.c
+++ b/drivers/net/wireless/ath/ath6kl/cfg80211.c
@@ -3326,6 +3326,27 @@
mask);
}
+static int ath6kl_cfg80211_set_txe_config(struct wiphy *wiphy,
+ struct net_device *dev,
+ u32 rate, u32 pkts, u32 intvl)
+{
+ struct ath6kl *ar = ath6kl_priv(dev);
+ struct ath6kl_vif *vif = netdev_priv(dev);
+
+ if (vif->nw_type != INFRA_NETWORK ||
+ !test_bit(ATH6KL_FW_CAPABILITY_TX_ERR_NOTIFY, ar->fw_capabilities))
+ return -EOPNOTSUPP;
+
+ if (vif->sme_state != SME_CONNECTED)
+ return -ENOTCONN;
+
+ /* save this since the firmware won't report the interval */
+ vif->txe_intvl = intvl;
+
+ return ath6kl_wmi_set_txe_notify(ar->wmi, vif->fw_vif_idx,
+ rate, pkts, intvl);
+}
+
static const struct ieee80211_txrx_stypes
ath6kl_mgmt_stypes[NUM_NL80211_IFTYPES] = {
[NL80211_IFTYPE_STATION] = {
@@ -3392,6 +3413,7 @@
.sched_scan_start = ath6kl_cfg80211_sscan_start,
.sched_scan_stop = ath6kl_cfg80211_sscan_stop,
.set_bitrate_mask = ath6kl_cfg80211_set_bitrate,
+ .set_cqm_txe_config = ath6kl_cfg80211_set_txe_config,
};
void ath6kl_cfg80211_stop(struct ath6kl_vif *vif)