tg3: Remove unused link config code
When tg3 devices are shutdown, the driver uses the
TG3_PHYFLG_IS_LOW_POWER flag to enable a static phy configuration.
Any attempt to use the link configuration variables is dead code. This
patch removes such code.
Signed-off-by: Matt Carlson <mcarlson@broadcom.com>
Reviewed-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/tg3.c b/drivers/net/ethernet/broadcom/tg3.c
index 27cf74c..610997c 100644
--- a/drivers/net/ethernet/broadcom/tg3.c
+++ b/drivers/net/ethernet/broadcom/tg3.c
@@ -3607,12 +3607,8 @@
tp->link_config.orig_autoneg = tp->link_config.autoneg;
}
- if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES)) {
- tp->link_config.speed = SPEED_10;
- tp->link_config.duplex = DUPLEX_HALF;
- tp->link_config.autoneg = AUTONEG_ENABLE;
+ if (!(tp->phy_flags & TG3_PHYFLG_ANY_SERDES))
tg3_setup_phy(tp, 0);
- }
}
if (GET_ASIC_REV(tp->pci_chip_rev_id) == ASIC_REV_5906) {