mtd: rawnand: move calls to ->select_chip() in nand_setup_data_interface()
After a ->set_features(TIMINGS), the chip is supposed to be working at a
new speed. In order for all the transactions to be perperly handled, the
NAND controller should also be configured to this same speed. Calling
->setup_data_interface() is not enough and the chip should be
de-asserted/re-asserted through calls to ->select_chip().
Prepare the next change in nand_setup_data_interface() where timings
will be checked after being applied. Because assertions of the CS pin
will be needed from within this function, move the calls to
->select_chip() inside nand_setup_data_interface() for later
consistency.
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Signed-off-by: Boris Brezillon <boris.brezillon@bootlin.com>
diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
index 2109fc2..9d5c273 100644
--- a/drivers/mtd/nand/raw/nand_base.c
+++ b/drivers/mtd/nand/raw/nand_base.c
@@ -1274,8 +1274,10 @@ static int nand_setup_data_interface(struct nand_chip *chip, int chipnr)
/* Change the mode on the chip side (if supported by the NAND chip) */
if (nand_supports_set_get_features(chip)) {
+ chip->select_chip(mtd, chipnr);
ret = nand_set_features(chip, ONFI_FEATURE_ADDR_TIMING_MODE,
tmode_param);
+ chip->select_chip(mtd, -1);
if (ret)
return ret;
}
@@ -2780,10 +2782,8 @@ int nand_reset(struct nand_chip *chip, int chipnr)
if (ret)
return ret;
- chip->select_chip(mtd, chipnr);
chip->data_interface = saved_data_intf;
ret = nand_setup_data_interface(chip, chipnr);
- chip->select_chip(mtd, -1);
if (ret)
return ret;
@@ -6505,10 +6505,7 @@ int nand_scan_tail(struct mtd_info *mtd)
/* Enter fastest possible mode on all dies. */
for (i = 0; i < chip->numchips; i++) {
- chip->select_chip(mtd, i);
ret = nand_setup_data_interface(chip, i);
- chip->select_chip(mtd, -1);
-
if (ret)
goto err_nand_manuf_cleanup;
}