ath10k: Extend CE src desc flags for interrupt indication
QCA99X0 uses two new copy engine src desc flags for interrupt
indication. Bit_2 is to mark if host interrupt is disabled after
processing the current desc and bit_3 is to mark if target interrupt
is diabled after the processing of current descriptor.
CE_DESC_FLAGS_META_DATA_MASK and CE_DESC_FLAGS_META_DATA_LSB are based
on the target type.
Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/ce.h b/drivers/net/wireless/ath/ath10k/ce.h
index bb4b8f3..5c903e15 100644
--- a/drivers/net/wireless/ath/ath10k/ce.h
+++ b/drivers/net/wireless/ath/ath10k/ce.h
@@ -38,8 +38,13 @@
#define CE_DESC_FLAGS_GATHER (1 << 0)
#define CE_DESC_FLAGS_BYTE_SWAP (1 << 1)
-#define CE_DESC_FLAGS_META_DATA_MASK 0xFFFC
-#define CE_DESC_FLAGS_META_DATA_LSB 2
+
+/* Following desc flags are used in QCA99X0 */
+#define CE_DESC_FLAGS_HOST_INT_DIS (1 << 2)
+#define CE_DESC_FLAGS_TGT_INT_DIS (1 << 3)
+
+#define CE_DESC_FLAGS_META_DATA_MASK ar->hw_values->ce_desc_meta_data_mask
+#define CE_DESC_FLAGS_META_DATA_LSB ar->hw_values->ce_desc_meta_data_lsb
struct ce_desc {
__le32 addr;