[PATCH] Altix: ioc3 serial support
Add driver support for a 2 port PCI IOC3-based serial card on Altix boxes:
This is a re-submission. On the original submission I was asked to
organize the code so that the MIPS ioc3 ethernet and serial parts could be
used with this driver. Stanislaw Skowronek was kind enough to provide the
shim layer for this - thanks Stanislaw. This patch includes the shim layer
and the Altix PCI ioc3 serial driver. The MIPS merged ioc3 ethernet and
serial support is forthcoming.
Signed-off-by: Patrick Gefre <pfg@sgi.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/sn/Kconfig b/drivers/sn/Kconfig
index 13b8d24..d95265b1 100644
--- a/drivers/sn/Kconfig
+++ b/drivers/sn/Kconfig
@@ -17,4 +17,18 @@
If you have an SGI Altix with an IOC4-based
I/O controller say Y. Otherwise say N.
+config SGI_IOC3
+ tristate "SGI IOC3 Base IO support"
+ depends on (IA64_GENERIC || IA64_SGI_SN2)
+ default m
+ ---help---
+ This option enables basic support for the SGI IOC3-based Base IO
+ controller card. This option does not enable any specific
+ functions on such a card, but provides necessary infrastructure
+ for other drivers to utilize.
+
+ If you have an SGI Altix with an IOC3-based
+ I/O controller or a PCI IOC3 serial card say Y.
+ Otherwise say N.
+
endmenu