mmc: core: Clarify usage of mmc_set_signal_voltage()
The mmc_set_signal_voltage() function is used for SD/SDIO when switching to
1.8V for UHS mode. To clarify this let's do the following changes.
- We are always providing MMC_SIGNAL_VOLTAGE_180 as the signal_voltage
parameter to the function. Then, let's just remove the parameter as it
serves no purpose.
- Rename the function to mmc_set_uhs_voltage().
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>
Tested-by: Jan Glauber <jglauber@cavium.com>
Tested-by: Stefan Wahren <stefan.wahren@i2se.com>
diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c
index 8b4f139..89531b4 100644
--- a/drivers/mmc/core/sd.c
+++ b/drivers/mmc/core/sd.c
@@ -788,8 +788,7 @@ int mmc_sd_get_cid(struct mmc_host *host, u32 ocr, u32 *cid, u32 *rocr)
*/
if (!mmc_host_is_spi(host) && rocr &&
((*rocr & 0x41000000) == 0x41000000)) {
- err = mmc_set_signal_voltage(host, MMC_SIGNAL_VOLTAGE_180,
- pocr);
+ err = mmc_set_uhs_voltage(host, pocr);
if (err == -EAGAIN) {
retries--;
goto try_again;