USB: serial: ftdi_sio: add device ID for Microsemi/Arrow SF2PLUS Dev Kit
This development kit has an FT4232 on it with a custom USB VID/PID.
The FT4232 provides four UARTs, but only two are used. The UART 0
is used by the FlashPro5 programmer and UART 2 is connected to the
SmartFusion2 CortexM3 SoC UART port.
Note that the USB VID is registered to Actel according to Linux USB
VID database, but that was acquired by Microsemi.
Signed-off-by: Marek Vasut <marex@denx.de>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: Johan Hovold <johan@kernel.org>
diff --git a/drivers/usb/serial/ftdi_sio.c b/drivers/usb/serial/ftdi_sio.c
index 5461712..d38780f 100644
--- a/drivers/usb/serial/ftdi_sio.c
+++ b/drivers/usb/serial/ftdi_sio.c
@@ -873,6 +873,7 @@ static const struct usb_device_id id_table_combined[] = {
{ USB_DEVICE_AND_INTERFACE_INFO(MICROCHIP_VID, MICROCHIP_USB_BOARD_PID,
USB_CLASS_VENDOR_SPEC,
USB_SUBCLASS_VENDOR_SPEC, 0x00) },
+ { USB_DEVICE_INTERFACE_NUMBER(ACTEL_VID, MICROSEMI_ARROW_SF2PLUS_BOARD_PID, 2) },
{ USB_DEVICE(JETI_VID, JETI_SPC1201_PID) },
{ USB_DEVICE(MARVELL_VID, MARVELL_SHEEVAPLUG_PID),
.driver_info = (kernel_ulong_t)&ftdi_jtag_quirk },