[POWERPC] CPM_UART: Removed __init from cpm_uart_init_portdesc to fix warning
cpm_uart_init_portdesc is referenced from non-init code and thus we were
getting the following warning:
WARNING: drivers/built-in.o - Section mismatch: reference to .init.text:cpm_uart_init_portdesc from .text between 'cpm_uart_init' (at offset 0x18020) and 'cpm_uart_drv_remove'
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/drivers/serial/cpm_uart/cpm_uart_cpm2.c b/drivers/serial/cpm_uart/cpm_uart_cpm2.c
index 1eeea36..7b61d80 100644
--- a/drivers/serial/cpm_uart/cpm_uart_cpm2.c
+++ b/drivers/serial/cpm_uart/cpm_uart_cpm2.c
@@ -282,7 +282,7 @@
}
/* Setup any dynamic params in the uart desc */
-int __init cpm_uart_init_portdesc(void)
+int cpm_uart_init_portdesc(void)
{
#if defined(CONFIG_SERIAL_CPM_SMC1) || defined(CONFIG_SERIAL_CPM_SMC2)
u16 *addr;