mmc: tmio: enable SoC specific DMA buswidth settings
Renesas SDHI which is based on TMIO driver has 2 type SoC. 1st one is
used as SH-Mobile series, and 2nd is R-Car series. R-Car series SoC has
DMA buswidth setting register which enables 32bit access.
This patch adds .dma_buswidth and enables it.
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
diff --git a/drivers/mmc/host/tmio_mmc_dma.c b/drivers/mmc/host/tmio_mmc_dma.c
index eb6b45c..aa5f4b6 100644
--- a/drivers/mmc/host/tmio_mmc_dma.c
+++ b/drivers/mmc/host/tmio_mmc_dma.c
@@ -293,7 +293,9 @@
cfg.slave_id = host->dma->slave_id_tx;
cfg.direction = DMA_MEM_TO_DEV;
cfg.dst_addr = res->start + (CTL_SD_DATA_PORT << host->bus_shift);
- cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
+ cfg.dst_addr_width = host->dma->dma_buswidth;
+ if (!cfg.dst_addr_width)
+ cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
cfg.src_addr = 0;
ret = dmaengine_slave_config(host->chan_tx, &cfg);
if (ret < 0)
@@ -312,7 +314,9 @@
cfg.slave_id = host->dma->slave_id_rx;
cfg.direction = DMA_DEV_TO_MEM;
cfg.src_addr = cfg.dst_addr + host->pdata->dma_rx_offset;
- cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
+ cfg.src_addr_width = host->dma->dma_buswidth;
+ if (!cfg.src_addr_width)
+ cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_2_BYTES;
cfg.dst_addr = 0;
ret = dmaengine_slave_config(host->chan_rx, &cfg);
if (ret < 0)