bridge: call netdev_sw_port_stp_update when bridge port STP status changes
To notify switch driver of change in STP state of bridge port, add new
.ndo op and provide switchdev wrapper func to call ndo op. Use it in bridge
code then.
Signed-off-by: Scott Feldman <sfeldma@gmail.com>
Signed-off-by: Jiri Pirko <jiri@resnulli.us>
Signed-off-by: Andy Gospodarek <gospo@cumulusnetworks.com>
Acked-by: Thomas Graf <tgraf@suug.ch>
Acked-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/include/linux/netdevice.h b/include/linux/netdevice.h
index 3603f31..29c92ee 100644
--- a/include/linux/netdevice.h
+++ b/include/linux/netdevice.h
@@ -1024,6 +1024,9 @@
* Called to get an ID of the switch chip this port is part of.
* If driver implements this, it indicates that it represents a port
* of a switch chip.
+ * int (*ndo_switch_port_stp_update)(struct net_device *dev, u8 state);
+ * Called to notify switch device port of bridge port STP
+ * state change.
*/
struct net_device_ops {
int (*ndo_init)(struct net_device *dev);
@@ -1180,6 +1183,8 @@
#ifdef CONFIG_NET_SWITCHDEV
int (*ndo_switch_parent_id_get)(struct net_device *dev,
struct netdev_phys_item_id *psid);
+ int (*ndo_switch_port_stp_update)(struct net_device *dev,
+ u8 state);
#endif
};