ath10k: add pdev param support to enable/disable btcoex
10.4 firmware has support to enable or disable btcoex functionality
without reloading firmware via wmi pdev param. Add provision to send
pdev param command via existing btcoex knob.
Signed-off-by: Rajkumar Manoharan <rmanohar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/wmi.h b/drivers/net/wireless/ath/ath10k/wmi.h
index 9fdf47e..90f594e 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.h
+++ b/drivers/net/wireless/ath/ath10k/wmi.h
@@ -3447,6 +3447,7 @@
u32 wapi_mbssid_offset;
u32 arp_srcaddr;
u32 arp_dstaddr;
+ u32 enable_btcoex;
};
#define WMI_PDEV_PARAM_UNSUPPORTED 0
@@ -3760,6 +3761,9 @@
WMI_10_4_PDEV_PARAM_ATF_OBSS_NOISE_SCH,
WMI_10_4_PDEV_PARAM_ATF_OBSS_NOISE_SCALING_FACTOR,
WMI_10_4_PDEV_PARAM_CUST_TXPOWER_SCALE,
+ WMI_10_4_PDEV_PARAM_ATF_DYNAMIC_ENABLE,
+ WMI_10_4_PDEV_PARAM_ATF_SSID_GROUP_POLICY,
+ WMI_10_4_PDEV_PARAM_ENABLE_BTCOEX,
};
struct wmi_pdev_set_param_cmd {