phy: Add USB speed related PHY modes
Add following USB speed related PHY modes:
LS (Low Speed), FS (Full Speed), HS (High Speed), SS (Super Speed)
Speed related information is required by some QCOM PHY drivers
to program PHY monitor resume/remote-wakeup events in suspended
state. Speed is needed in order to set correct polarity of wakeup
events for detection. E.g. QUSB2 PHY monitors DP/DM line state
depending on whether speed is LS or FS/HS to detect resume.
Similarly QMP USB3 PHY in SS mode should monitor RX terminations
attach/detach and LFPS events depending on SSPHY is active or not.
Signed-off-by: Manu Gautam <mgautam@codeaurora.org>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
diff --git a/include/linux/phy/phy.h b/include/linux/phy/phy.h
index 4f8423a..485469e 100644
--- a/include/linux/phy/phy.h
+++ b/include/linux/phy/phy.h
@@ -25,7 +25,15 @@ struct phy;
enum phy_mode {
PHY_MODE_INVALID,
PHY_MODE_USB_HOST,
+ PHY_MODE_USB_HOST_LS,
+ PHY_MODE_USB_HOST_FS,
+ PHY_MODE_USB_HOST_HS,
+ PHY_MODE_USB_HOST_SS,
PHY_MODE_USB_DEVICE,
+ PHY_MODE_USB_DEVICE_LS,
+ PHY_MODE_USB_DEVICE_FS,
+ PHY_MODE_USB_DEVICE_HS,
+ PHY_MODE_USB_DEVICE_SS,
PHY_MODE_USB_OTG,
PHY_MODE_SGMII,
PHY_MODE_10GKR,
@@ -61,6 +69,7 @@ struct phy_ops {
*/
struct phy_attrs {
u32 bus_width;
+ enum phy_mode mode;
};
/**
@@ -144,6 +153,10 @@ int phy_exit(struct phy *phy);
int phy_power_on(struct phy *phy);
int phy_power_off(struct phy *phy);
int phy_set_mode(struct phy *phy, enum phy_mode mode);
+static inline enum phy_mode phy_get_mode(struct phy *phy)
+{
+ return phy->attrs.mode;
+}
int phy_reset(struct phy *phy);
int phy_calibrate(struct phy *phy);
static inline int phy_get_bus_width(struct phy *phy)
@@ -260,6 +273,11 @@ static inline int phy_set_mode(struct phy *phy, enum phy_mode mode)
return -ENOSYS;
}
+static inline enum phy_mode phy_get_mode(struct phy *phy)
+{
+ return PHY_MODE_INVALID;
+}
+
static inline int phy_reset(struct phy *phy)
{
if (!phy)