EHCI: maintain the ehci->command value properly
The ehci-hcd driver is a little haphazard about keeping track of the
state of the USBCMD register. The ehci->command field is supposed to
hold the register's value (apart from a few special bits) at all
times, but it isn't maintained properly.
This patch (as1543) cleans up the situation. It keeps ehci->command
up-to-date, and uses that value rather than reading the register from
the hardware whenever possible.
Signed-off-by: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/host/ehci-dbg.c b/drivers/usb/host/ehci-dbg.c
index 680e1a3..7561966 100644
--- a/drivers/usb/host/ehci-dbg.c
+++ b/drivers/usb/host/ehci-dbg.c
@@ -1025,10 +1025,8 @@
if (strict_strtoul(buf + 5, 16, &hird))
return -EINVAL;
printk(KERN_INFO "setting hird %s %lu\n", buf + 6, hird);
- temp = ehci_readl(ehci, &ehci->regs->command);
- temp &= ~CMD_HIRD;
- temp |= hird << 24;
- ehci_writel(ehci, temp, &ehci->regs->command);
+ ehci->command = (ehci->command & ~CMD_HIRD) | (hird << 24);
+ ehci_writel(ehci, ehci->command, &ehci->regs->command);
} else if (strncmp(buf, "disable", 7) == 0) {
if (strict_strtoul(buf + 8, 10, &port))
return -EINVAL;