iwlwifi: mvm: use proper sta_addr in firmware API
There's no point to declare an address as a __le32/__le16
and then only take a pointer to it anyway, change that to
just a sta_addr[ETH_ALEN].
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>
diff --git a/drivers/net/wireless/intel/iwlwifi/mvm/fw-api-tx.h b/drivers/net/wireless/intel/iwlwifi/mvm/fw-api-tx.h
index 81b9891..c03fbb8 100644
--- a/drivers/net/wireless/intel/iwlwifi/mvm/fw-api-tx.h
+++ b/drivers/net/wireless/intel/iwlwifi/mvm/fw-api-tx.h
@@ -594,8 +594,7 @@ struct iwl_mvm_tx_resp {
/**
* struct iwl_mvm_ba_notif - notifies about reception of BA
* ( BA_NOTIF = 0xc5 )
- * @sta_addr_lo32: lower 32 bits of the MAC address
- * @sta_addr_hi16: upper 16 bits of the MAC address
+ * @sta_addr: MAC address
* @sta_id: Index of recipient (BA-sending) station in fw's station table
* @tid: tid of the session
* @seq_ctl:
@@ -609,8 +608,7 @@ struct iwl_mvm_tx_resp {
* for Tx-ing then this value will be set to 0 by FW.
*/
struct iwl_mvm_ba_notif {
- __le32 sta_addr_lo32;
- __le16 sta_addr_hi16;
+ u8 sta_addr[ETH_ALEN];
__le16 reserved;
u8 sta_id;