net/mlx5: QPTS and QPDPM register firmware command support
The QPTS register allows changing the priority trust state between pcp and
dscp. Add support to get/set trust state from device. When the port is
in pcp/dscp trust state, packet is routed by hardware to matching priority
based on its pcp/dscp value respectively.
The QPDPM register allow channing the dscp to priority mapping. Add support
to get/set dscp to priority mapping from device.
Note that to change a dscp mapping, the "e" bit of this dscp structure
must be set in the QPDPM firmware command.
Signed-off-by: Huy Nguyen <huyn@mellanox.com>
Reviewed-by: Parav Pandit <parav@mellanox.com>
Reviewed-by: Or Gerlitz <ogerlitz@mellanox.com>
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>
diff --git a/include/linux/mlx5/mlx5_ifc.h b/include/linux/mlx5/mlx5_ifc.h
index f127c5b..3e5363f 100644
--- a/include/linux/mlx5/mlx5_ifc.h
+++ b/include/linux/mlx5/mlx5_ifc.h
@@ -8578,6 +8578,26 @@ struct mlx5_ifc_qetc_reg_bits {
struct mlx5_ifc_ets_global_config_reg_bits global_configuration;
};
+struct mlx5_ifc_qpdpm_dscp_reg_bits {
+ u8 e[0x1];
+ u8 reserved_at_01[0x0b];
+ u8 prio[0x04];
+};
+
+struct mlx5_ifc_qpdpm_reg_bits {
+ u8 reserved_at_0[0x8];
+ u8 local_port[0x8];
+ u8 reserved_at_10[0x10];
+ struct mlx5_ifc_qpdpm_dscp_reg_bits dscp[64];
+};
+
+struct mlx5_ifc_qpts_reg_bits {
+ u8 reserved_at_0[0x8];
+ u8 local_port[0x8];
+ u8 reserved_at_10[0x2d];
+ u8 trust_state[0x3];
+};
+
struct mlx5_ifc_qtct_reg_bits {
u8 reserved_at_0[0x8];
u8 port_number[0x8];