ath9k: perform ANI cycle in idle state
As of now the ANI cycle is executed only when the chip is awake.
On idle state case, the station wakes up from network sleep for
beacon reception. Since most of the time, ANI cycle is not syncing
with beacon wakeup, ANI cycle is ignored. Approx 5 mins once, the
calibration is performed. This could affect the connection stability
when the station is idle for long. Even though the OFDM and CCK phy
error rates are too high, ANI is unable to tune its immunity level
as quick enough due to rare execution.
Here the experiment shows that OFDM and CCK levels are at default
even on higher phy error rate.
listenTime=44 OFDM:3 errs=121977/s CCK:2 errs=440818/s ofdm_turn=1
This change ensures that ANI calibration will be exectued atleast
once for every 10 seconds. The below result shows improvements and
immunity levels are adopted quick enough.
listenTime=557 OFDM:4 errs=752/s CCK:4 errs=125/s ofdm_turn=0
Signed-off-by: Rajkumar Manoharan <rmanohar@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/ath9k.h b/drivers/net/wireless/ath/ath9k/ath9k.h
index dfe6a47..77c2c16 100644
--- a/drivers/net/wireless/ath/ath9k/ath9k.h
+++ b/drivers/net/wireless/ath/ath9k/ath9k.h
@@ -437,6 +437,7 @@
#define ATH_LONG_CALINTERVAL_INT 1000 /* 1000 ms */
#define ATH_LONG_CALINTERVAL 30000 /* 30 seconds */
#define ATH_RESTART_CALINTERVAL 1200000 /* 20 minutes */
+#define ATH_ANI_MAX_SKIP_COUNT 10
#define ATH_PAPRD_TIMEOUT 100 /* msecs */
#define ATH_PLL_WORK_INTERVAL 100
@@ -642,6 +643,7 @@
#define PS_WAIT_FOR_PSPOLL_DATA BIT(2)
#define PS_WAIT_FOR_TX_ACK BIT(3)
#define PS_BEACON_SYNC BIT(4)
+#define PS_WAIT_FOR_ANI BIT(5)
struct ath_rate_table;