batman-adv: set the isolation mark in the skb if needed
If a broadcast packet is coming from a client marked as
isolated, then mark the skb using the isolation mark so
that netfilter (or any other application) can recognise
them.
The mark is written in the skb based on the mask value:
only bits set in the mask are substitued by those in the
mark value
Signed-off-by: Antonio Quartulli <antonio@open-mesh.com>
Signed-off-by: Marek Lindner <mareklindner@neomailbox.ch>
diff --git a/net/batman-adv/soft-interface.c b/net/batman-adv/soft-interface.c
index e126d74..c50f643 100644
--- a/net/batman-adv/soft-interface.c
+++ b/net/batman-adv/soft-interface.c
@@ -399,9 +399,23 @@
batadv_tt_add_temporary_global_entry(bat_priv, orig_node,
ethhdr->h_source, vid);
- if (batadv_is_ap_isolated(bat_priv, ethhdr->h_source, ethhdr->h_dest,
- vid))
+ if (is_multicast_ether_addr(ethhdr->h_dest)) {
+ /* set the mark on broadcast packets if AP isolation is ON and
+ * the packet is coming from an "isolated" client
+ */
+ if (batadv_vlan_ap_isola_get(bat_priv, vid) &&
+ batadv_tt_global_is_isolated(bat_priv, ethhdr->h_source,
+ vid)) {
+ /* save bits in skb->mark not covered by the mask and
+ * apply the mark on the rest
+ */
+ skb->mark &= ~bat_priv->isolation_mark_mask;
+ skb->mark |= bat_priv->isolation_mark;
+ }
+ } else if (batadv_is_ap_isolated(bat_priv, ethhdr->h_source,
+ ethhdr->h_dest, vid)) {
goto dropped;
+ }
netif_rx(skb);
goto out;