qed: iWARP CM add passive side connect
This patch implements the passive side connect.
It addresses pre-allocating resources, creating a connection
element upon valid SYN packet received. Calling upper layer and
implementation of the accept/reject calls.
Error handling is not part of this patch.
Signed-off-by: Michal Kalderon <Michal.Kalderon@cavium.com>
Signed-off-by: Yuval Mintz <Yuval.Mintz@cavium.com>
Signed-off-by: Ariel Elior <Ariel.Elior@cavium.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/qlogic/qed/qed_rdma.h b/drivers/net/ethernet/qlogic/qed/qed_rdma.h
index 90e4e0f..18ec9cb 100644
--- a/drivers/net/ethernet/qlogic/qed/qed_rdma.h
+++ b/drivers/net/ethernet/qlogic/qed/qed_rdma.h
@@ -85,6 +85,7 @@ struct qed_rdma_info {
struct qed_bmap qp_map;
struct qed_bmap srq_map;
struct qed_bmap cid_map;
+ struct qed_bmap tcp_cid_map;
struct qed_bmap real_cid_map;
struct qed_bmap dpi_map;
struct qed_bmap toggle_bits;
@@ -167,6 +168,7 @@ struct qed_rdma_qp {
void *shared_queue;
dma_addr_t shared_queue_phys_addr;
+ struct qed_iwarp_ep *ep;
};
#if IS_ENABLED(CONFIG_QED_RDMA)