iwlwifi: check for aggregation frame and queue
Error checking for aggregation frames should go into aggregation queue,
if aggregation queue not available, use legacy queue instead.
Also make sure the aggregation queue is available to activate,
if driver and mac80211 is out-of-sync, try to disable the queue and
sync-up with mac80211.
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-agn-rs.c b/drivers/net/wireless/iwlwifi/iwl-agn-rs.c
index 6aebced..8bf7c20 100644
--- a/drivers/net/wireless/iwlwifi/iwl-agn-rs.c
+++ b/drivers/net/wireless/iwlwifi/iwl-agn-rs.c
@@ -298,10 +298,23 @@
struct iwl_lq_sta *lq_data, u8 tid,
struct ieee80211_sta *sta)
{
+ int ret;
+
if (rs_tl_get_load(lq_data, tid) > IWL_AGG_LOAD_THRESHOLD) {
IWL_DEBUG_HT(priv, "Starting Tx agg: STA: %pM tid: %d\n",
sta->addr, tid);
- ieee80211_start_tx_ba_session(sta, tid);
+ ret = ieee80211_start_tx_ba_session(sta, tid);
+ if (ret == -EAGAIN) {
+ /*
+ * driver and mac80211 is out of sync
+ * this might be cause by reloading firmware
+ * stop the tx ba session here
+ */
+ IWL_DEBUG_HT(priv, "Fail start Tx agg on tid: %d\n",
+ tid);
+ ret = ieee80211_stop_tx_ba_session(sta, tid,
+ WLAN_BACK_INITIATOR);
+ }
}
}