mwifiex: add multi-queue support
This patch adds support for multiple TX queues inside mwifiex
driver. Four different queues according to WMM access categories
are defined for each virtual interface. When a packet is
received from netdev for transmission, tx pending count for
particular queue is incremented and if tx pending count has
reached upper water-mark, this queue is stopped instead of
stopping all queues. Similarly when a packet is successfully
transmitted from device, tx pending count is decremented per
queue and if pending count falls below lower water-mark, queue
operations are again resumed. This ensures that not all
tranmission is blocked if traffic with particular TOS value
suddenly increases.
Also wake all queues after association/IBSS_join/uAP_BSS_start
to enable traffic on all queues.
Signed-off-by: Avinash Patil <patila@marvell.com>
Signed-off-by: Bing Zhao <bzhao@marvell.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/mwifiex/uap_event.c b/drivers/net/wireless/mwifiex/uap_event.c
index a33fa39..21c640d 100644
--- a/drivers/net/wireless/mwifiex/uap_event.c
+++ b/drivers/net/wireless/mwifiex/uap_event.c
@@ -235,11 +235,18 @@
break;
case EVENT_UAP_BSS_IDLE:
priv->media_connected = false;
+ if (netif_carrier_ok(priv->netdev))
+ netif_carrier_off(priv->netdev);
+ mwifiex_stop_net_dev_queue(priv->netdev, adapter);
+
mwifiex_clean_txrx(priv);
mwifiex_del_all_sta_list(priv);
break;
case EVENT_UAP_BSS_ACTIVE:
priv->media_connected = true;
+ if (!netif_carrier_ok(priv->netdev))
+ netif_carrier_on(priv->netdev);
+ mwifiex_wake_up_net_dev_queue(priv->netdev, adapter);
break;
case EVENT_UAP_BSS_START:
dev_dbg(adapter->dev, "AP EVENT: event id: %#x\n", eventcause);