wil6210: reset flow updates
As communicated with the firmware & hardware teams
Signed-off-by: Vladimir Kondratiev <qca_vkondrat@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/wil6210/main.c b/drivers/net/wireless/ath/wil6210/main.c
index 7900384..0e95557 100644
--- a/drivers/net/wireless/ath/wil6210/main.c
+++ b/drivers/net/wireless/ath/wil6210/main.c
@@ -400,7 +400,7 @@
static int wil_target_reset(struct wil6210_priv *wil)
{
int delay = 0;
- u32 hw_state;
+ u32 x;
u32 rev_id;
bool is_sparrow = (wil->board->board == WIL_BOARD_SPARROW);
@@ -415,9 +415,22 @@
S(RGF_USER_CLKS_CTL_SW_RST_MASK_0, BIT_CAR_PERST_RST);
wil_halt_cpu(wil);
- C(RGF_USER_CLKS_CTL_0, BIT_USER_CLKS_CAR_AHB_SW_SEL); /* 40 MHz */
if (is_sparrow) {
+ S(RGF_CAF_OSC_CONTROL, BIT_CAF_OSC_XTAL_EN);
+ /* XTAL stabilization should take about 3ms */
+ usleep_range(5000, 7000);
+ x = R(RGF_CAF_PLL_LOCK_STATUS);
+ if (!(x & BIT_CAF_OSC_DIG_XTAL_STABLE)) {
+ wil_err(wil, "Xtal stabilization timeout\n"
+ "RGF_CAF_PLL_LOCK_STATUS = 0x%08x\n", x);
+ return -ETIME;
+ }
+ /* switch 10k to XTAL*/
+ C(RGF_USER_SPARROW_M_4, BIT_SPARROW_M_4_SEL_SLEEP_OR_REF);
+ /* 40 MHz */
+ C(RGF_USER_CLKS_CTL_0, BIT_USER_CLKS_CAR_AHB_SW_SEL);
+
W(RGF_USER_CLKS_CTL_EXT_SW_RST_VEC_0, 0x3ff81f);
W(RGF_USER_CLKS_CTL_EXT_SW_RST_VEC_1, 0xf);
}
@@ -458,13 +471,13 @@
/* wait until device ready. typical time is 200..250 msec */
do {
msleep(RST_DELAY);
- hw_state = R(RGF_USER_HW_MACHINE_STATE);
+ x = R(RGF_USER_HW_MACHINE_STATE);
if (delay++ > RST_COUNT) {
wil_err(wil, "Reset not completed, hw_state 0x%08x\n",
- hw_state);
+ x);
return -ETIME;
}
- } while (hw_state != HW_MACHINE_BOOT_DONE);
+ } while (x != HW_MACHINE_BOOT_DONE);
/* TODO: Erez check rev_id != 1 */
if (!is_sparrow && (rev_id != 1))