[SCSI] mpt2sas: fix firmware failure with wrong task attribute
When SCSI command is received with task attribute not set, set it to SIMPLE.
Previously it is set to untagged. This causes the firmware to fail the commands.
Signed-off-by: Sreekanth Reddy <Sreekanth.Reddy@lsi.com>
Cc: stable@vger.kernel.org
Signed-off-by: James Bottomley <JBottomley@Parallels.com>
diff --git a/drivers/scsi/mpt2sas/mpt2sas_scsih.c b/drivers/scsi/mpt2sas/mpt2sas_scsih.c
index 01dfbab..c78216c 100644
--- a/drivers/scsi/mpt2sas/mpt2sas_scsih.c
+++ b/drivers/scsi/mpt2sas/mpt2sas_scsih.c
@@ -3998,11 +3998,7 @@
else
mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
} else
-/* MPI Revision I (UNIT = 0xA) - removed MPI2_SCSIIO_CONTROL_UNTAGGED */
-/* mpi_control |= MPI2_SCSIIO_CONTROL_UNTAGGED;
- */
- mpi_control |= (0x500);
-
+ mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
} else
mpi_control |= MPI2_SCSIIO_CONTROL_SIMPLEQ;
/* Make sure Device is not raid volume.