net: dsa: use dsa_is_user_port everywhere
Most of the DSA code still check ds->enabled_port_mask directly to
inspect a given port type instead of using the provided dsa_is_user_port
helper. Change this.
Signed-off-by: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/dsa/mt7530.c b/drivers/net/dsa/mt7530.c
index 21431be..d1d4eea6 100644
--- a/drivers/net/dsa/mt7530.c
+++ b/drivers/net/dsa/mt7530.c
@@ -781,7 +781,7 @@ mt7530_port_bridge_join(struct dsa_switch *ds, int port,
* same bridge. If the port is disabled, port matrix is kept
* and not being setup until the port becomes enabled.
*/
- if (ds->enabled_port_mask & BIT(i) && i != port) {
+ if (dsa_is_user_port(ds, i) && i != port) {
if (dsa_to_port(ds, i)->bridge_dev != bridge)
continue;
if (priv->ports[i].enable)
@@ -818,7 +818,7 @@ mt7530_port_bridge_leave(struct dsa_switch *ds, int port,
* in the same bridge. If the port is disabled, port matrix
* is kept and not being setup until the port becomes enabled.
*/
- if (ds->enabled_port_mask & BIT(i) && i != port) {
+ if (dsa_is_user_port(ds, i) && i != port) {
if (dsa_to_port(ds, i)->bridge_dev != bridge)
continue;
if (priv->ports[i].enable)