serial: sh-sci: Support generic SCLSR overrun detection.
For all ports with a valid SCLSR register we can use the generic FIFO
overrun detection logic. Test the validity of the SCLSR register rather
than depending explicitly on port type, which can be ambiguous for the
SCIFA/B types.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index 60027d5..8e55e0a 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -734,15 +734,11 @@
{
struct tty_struct *tty = port->state->port.tty;
struct sci_port *s = to_sci_port(port);
+ struct plat_sci_reg *reg;
int copied = 0;
- /*
- * XXX: Technically not limited to non-SCIFs, it's simply the
- * SCLSR check that is for the moment SCIF-specific. This
- * probably wants to be revisited for SCIFA/B as well as for
- * factoring in SCI overrun detection.
- */
- if (port->type != PORT_SCIF)
+ reg = sci_getreg(port, SCLSR);
+ if (!reg->size)
return 0;
if ((sci_in(port, SCLSR) & (1 << s->cfg->overrun_bit))) {