ARM i.MX ehci: do ehci init in board specific functions
The mxc-ehci driver calls SoC specific phy initialization right after
calling board specific initialization. To offer greater flexibility for
boards to setup the phy and to get rid of some unnecessary flags in
platform data this patch lets the boards call the SoC specific phy
initialization and remove it from the driver.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
diff --git a/arch/arm/mach-mx3/mach-mx31moboard.c b/arch/arm/mach-mx3/mach-mx31moboard.c
index fd988a0..ea88033 100644
--- a/arch/arm/mach-mx3/mach-mx31moboard.c
+++ b/arch/arm/mach-mx3/mach-mx31moboard.c
@@ -401,10 +401,14 @@
}
#if defined(CONFIG_USB_ULPI)
+static int moboard_usbh2_init_hw(struct platform_device *pdev)
+{
+ return mx31_initialize_usb_hw(pdev->id, MXC_EHCI_POWER_PINS_ENABLED);
+}
static struct mxc_usbh_platform_data usbh2_pdata __initdata = {
+ .init = moboard_usbh2_init_hw,
.portsc = MXC_EHCI_MODE_ULPI | MXC_EHCI_UTMI_8BIT,
- .flags = MXC_EHCI_POWER_PINS_ENABLED,
};
static int __init moboard_usbh2_init(void)