Merge branch 'netdev_print'
Veaceslav Falico says:
====================
net: print net_device name/state more often
Currently we use net_device->name only if it's the NETREG_REGISTERED
reg_state, otherwise we return "(unregistered device)".
However, we always populate net_device->name on creation, so it's always
available to us for use. The only caveat is that we might have a name like
"eth%d", in which case we cannot use it as it might change in the future.
Also, the net_device might not be NETREG_UNREGISTERED when the function is
called (_UNINITIALIZED, _UNREGISTERING, _RELEASED, _DUMMY), so it's
misleading.
So, a better way would be to always return the dev->name in netdev_name(),
unless it's in the form of "eth%d" or it's empty, then return
"unnamed net_device". This way we'll always return the name in
NETREG_REGISTERED reg_state, and also return it in other states, when
possible.
Also, to be more verbose on non-NETREG_REGISTERED states, add a function
netdev_reg_state(), which returns a string describing the state, and use it
in netdev_printk()-related functions. If the dev is in NETREG_REGISTERED
state then a void string is regurned and, thus, nothing changes.
After these two patches we'll have the same behaviour in the usual cases,
and more verbose in non-standardad/buggy ones.
v2->v3:
Correct the string for _UNINITIALIZED and warn on a bad reg_state,
per Joe Perches's comments.
v1->v2:
As Tom Gundersen suggested, there might be a case when we have an empty
string as a name for a device, so account this also and return "unnamed
device" for that case too.
====================
Signed-off-by: Veaceslav Falico <vfalico@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>