POWERPC: Allow 32-bit hashed pgtable code to support 36-bit physical
This rearranges a bit of code, and adds support for
36-bit physical addressing for configs that use a
hashed page table. The 36b physical support is not
enabled by default on any config - it must be
explicitly enabled via the config system.
This patch *only* expands the page table code to accomodate
large physical addresses on 32-bit systems and enables the
PHYS_64BIT config option for 86xx. It does *not*
allow you to boot a board with more than about 3.5GB of
RAM - for that, SWIOTLB support is also required (and
coming soon).
Signed-off-by: Becky Bruce <becky.bruce@freescale.com>
Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
diff --git a/arch/powerpc/mm/pgtable_32.c b/arch/powerpc/mm/pgtable_32.c
index 2001abd..c31d6d2 100644
--- a/arch/powerpc/mm/pgtable_32.c
+++ b/arch/powerpc/mm/pgtable_32.c
@@ -73,7 +73,7 @@
#endif /* HAVE_TLBCAM */
#ifdef CONFIG_PTE_64BIT
-/* 44x uses an 8kB pgdir because it has 8-byte Linux PTEs. */
+/* Some processors use an 8kB pgdir because they have 8-byte Linux PTEs. */
#define PGDIR_ORDER 1
#else
#define PGDIR_ORDER 0
@@ -288,7 +288,7 @@
}
/*
- * Map in all of physical memory starting at KERNELBASE.
+ * Map in a big chunk of physical memory starting at KERNELBASE.
*/
void __init mapin_ram(void)
{