e1000: move e1000_tbi_adjust_stats to where its used

... and make it static.

Signed-off-by: Florian Westphal <fw@strlen.de>
Tested-by: Aaron Brown <aaron.f.brown@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
diff --git a/drivers/net/ethernet/intel/e1000/e1000_main.c b/drivers/net/ethernet/intel/e1000/e1000_main.c
index ad3d5d1..fe2b9ad 100644
--- a/drivers/net/ethernet/intel/e1000/e1000_main.c
+++ b/drivers/net/ethernet/intel/e1000/e1000_main.c
@@ -3981,6 +3981,83 @@
 }
 
 /**
+ * e1000_tbi_adjust_stats
+ * @hw: Struct containing variables accessed by shared code
+ * @frame_len: The length of the frame in question
+ * @mac_addr: The Ethernet destination address of the frame in question
+ *
+ * Adjusts the statistic counters when a frame is accepted by TBI_ACCEPT
+ */
+static void e1000_tbi_adjust_stats(struct e1000_hw *hw,
+				   struct e1000_hw_stats *stats,
+				   u32 frame_len, const u8 *mac_addr)
+{
+	u64 carry_bit;
+
+	/* First adjust the frame length. */
+	frame_len--;
+	/* We need to adjust the statistics counters, since the hardware
+	 * counters overcount this packet as a CRC error and undercount
+	 * the packet as a good packet
+	 */
+	/* This packet should not be counted as a CRC error. */
+	stats->crcerrs--;
+	/* This packet does count as a Good Packet Received. */
+	stats->gprc++;
+
+	/* Adjust the Good Octets received counters */
+	carry_bit = 0x80000000 & stats->gorcl;
+	stats->gorcl += frame_len;
+	/* If the high bit of Gorcl (the low 32 bits of the Good Octets
+	 * Received Count) was one before the addition,
+	 * AND it is zero after, then we lost the carry out,
+	 * need to add one to Gorch (Good Octets Received Count High).
+	 * This could be simplified if all environments supported
+	 * 64-bit integers.
+	 */
+	if (carry_bit && ((stats->gorcl & 0x80000000) == 0))
+		stats->gorch++;
+	/* Is this a broadcast or multicast?  Check broadcast first,
+	 * since the test for a multicast frame will test positive on
+	 * a broadcast frame.
+	 */
+	if (is_broadcast_ether_addr(mac_addr))
+		stats->bprc++;
+	else if (is_multicast_ether_addr(mac_addr))
+		stats->mprc++;
+
+	if (frame_len == hw->max_frame_size) {
+		/* In this case, the hardware has overcounted the number of
+		 * oversize frames.
+		 */
+		if (stats->roc > 0)
+			stats->roc--;
+	}
+
+	/* Adjust the bin counters when the extra byte put the frame in the
+	 * wrong bin. Remember that the frame_len was adjusted above.
+	 */
+	if (frame_len == 64) {
+		stats->prc64++;
+		stats->prc127--;
+	} else if (frame_len == 127) {
+		stats->prc127++;
+		stats->prc255--;
+	} else if (frame_len == 255) {
+		stats->prc255++;
+		stats->prc511--;
+	} else if (frame_len == 511) {
+		stats->prc511++;
+		stats->prc1023--;
+	} else if (frame_len == 1023) {
+		stats->prc1023++;
+		stats->prc1522--;
+	} else if (frame_len == 1522) {
+		stats->prc1522++;
+	}
+}
+
+/**
  * e1000_clean_jumbo_rx_irq - Send received data up the network stack; legacy
  * @adapter: board private structure
  * @rx_ring: ring to clean