ipvlan: Introduce l3s mode
In a typical IPvlan L3 setup where master is in default-ns and
each slave is into different (slave) ns. In this setup egress
packet processing for traffic originating from slave-ns will
hit all NF_HOOKs in slave-ns as well as default-ns. However same
is not true for ingress processing. All these NF_HOOKs are
hit only in the slave-ns skipping them in the default-ns.
IPvlan in L3 mode is restrictive and if admins want to deploy
iptables rules in default-ns, this asymmetric data path makes it
impossible to do so.
This patch makes use of the l3_rcv() (added as part of l3mdev
enhancements) to perform input route lookup on RX packets without
changing the skb->dev and then uses nf_hook at NF_INET_LOCAL_IN
to change the skb->dev just before handing over skb to L4.
Signed-off-by: Mahesh Bandewar <maheshb@google.com>
CC: David Ahern <dsa@cumulusnetworks.com>
Reviewed-by: David Ahern <dsa@cumulusnetworks.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ipvlan/ipvlan.h b/drivers/net/ipvlan/ipvlan.h
index 695a5dc..7e0732f 100644
--- a/drivers/net/ipvlan/ipvlan.h
+++ b/drivers/net/ipvlan/ipvlan.h
@@ -23,11 +23,13 @@
#include <linux/if_vlan.h>
#include <linux/ip.h>
#include <linux/inetdevice.h>
+#include <linux/netfilter.h>
#include <net/ip.h>
#include <net/ip6_route.h>
#include <net/rtnetlink.h>
#include <net/route.h>
#include <net/addrconf.h>
+#include <net/l3mdev.h>
#define IPVLAN_DRV "ipvlan"
#define IPV_DRV_VER "0.1"
@@ -124,4 +126,8 @@
const void *iaddr, bool is_v6);
bool ipvlan_addr_busy(struct ipvl_port *port, void *iaddr, bool is_v6);
void ipvlan_ht_addr_del(struct ipvl_addr *addr);
+struct sk_buff *ipvlan_l3_rcv(struct net_device *dev, struct sk_buff *skb,
+ u16 proto);
+unsigned int ipvlan_nf_input(void *priv, struct sk_buff *skb,
+ const struct nf_hook_state *state);
#endif /* __IPVLAN_H */