ath9k: use the right hw on ath_tx_setup_buffer() for HT
When using virtual wiphys the base sc->hw was being used, the correct
hw is passed along the caller already so just use that.
Cc: Jouni.Malinen <Jouni.Malinen@atheros.com>
Signed-off-by: Luis R. Rodriguez <lrodriguez@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/ath9k/xmit.c b/drivers/net/wireless/ath/ath9k/xmit.c
index 6d7f0bc..fc06768 100644
--- a/drivers/net/wireless/ath/ath9k/xmit.c
+++ b/drivers/net/wireless/ath/ath9k/xmit.c
@@ -1576,7 +1576,7 @@
bf->bf_frmlen = skb->len + FCS_LEN - (hdrlen & 3);
- if (conf_is_ht(&sc->hw->conf) && !is_pae(skb))
+ if (conf_is_ht(&hw->conf) && !is_pae(skb))
bf->bf_state.bf_type |= BUF_HT;
bf->bf_flags = setup_tx_flags(sc, skb, txctl->txq);